Calling nand_read_page_op(pagesize)/nand_prog_page_begin_op(pagesize) and expecting to get a pagesize+oobsize read from/written to the read/write buffer is fragile and only works because of hacks done in cmdfunc(). Let's read/write the page in one go, using the page cache buffer as a bounce buffer instead of relying on guesses done in cafe_nand_cmdfunc(). Signed-off-by: Boris Brezillon <boris.brezillon@xxxxxxxxxxxxx> Tested-by: Lubomir Rintel <lkundrak@xxxxx> --- Changes in v2: * Add T-b * None --- drivers/mtd/nand/raw/cafe_nand.c | 16 +++++++++++----- 1 file changed, 11 insertions(+), 5 deletions(-) diff --git a/drivers/mtd/nand/raw/cafe_nand.c b/drivers/mtd/nand/raw/cafe_nand.c index f7e537836d55..36685bee9d83 100644 --- a/drivers/mtd/nand/raw/cafe_nand.c +++ b/drivers/mtd/nand/raw/cafe_nand.c @@ -470,6 +470,7 @@ static int cafe_nand_read_page(struct nand_chip *chip, uint8_t *buf, { struct mtd_info *mtd = nand_to_mtd(chip); struct cafe_priv *cafe = nand_get_controller_data(chip); + void *pagebuf = nand_get_data_buf(chip); unsigned int max_bitflips = 0; u32 ecc_result, status; @@ -477,8 +478,11 @@ static int cafe_nand_read_page(struct nand_chip *chip, uint8_t *buf, cafe_readl(cafe, NAND_ECC_RESULT), cafe_readl(cafe, NAND_ECC_SYN_REG(0))); - nand_read_page_op(chip, page, 0, buf, mtd->writesize); - chip->legacy.read_buf(chip, chip->oob_poi, mtd->oobsize); + nand_read_page_op(chip, page, 0, pagebuf, + mtd->writesize + mtd->oobsize); + + if (buf != pagebuf) + memcpy(buf, pagebuf, mtd->writesize); ecc_result = cafe_readl(cafe, NAND_ECC_RESULT); status = CAFE_FIELD_GET(NAND_ECC_RESULT, STATUS, ecc_result); @@ -640,15 +644,17 @@ static int cafe_nand_write_page(struct nand_chip *chip, { struct mtd_info *mtd = nand_to_mtd(chip); struct cafe_priv *cafe = nand_get_controller_data(chip); + void *pagebuf = nand_get_data_buf(chip); int ret; - nand_prog_page_begin_op(chip, page, 0, buf, mtd->writesize); - chip->legacy.write_buf(chip, chip->oob_poi, mtd->oobsize); + if (pagebuf != buf) + memcpy(pagebuf, buf, mtd->writesize); /* Set up ECC autogeneration */ cafe->ctl2 |= CAFE_NAND_CTRL2_AUTO_WRITE_ECC; - ret = nand_prog_page_end_op(chip); + ret = nand_prog_page_op(chip, page, 0, pagebuf, + mtd->writesize + mtd->oobsize); /* * And clear it before returning so that following write operations -- 2.25.3 ______________________________________________________ Linux MTD discussion mailing list http://lists.infradead.org/mailman/listinfo/linux-mtd/