Re: [PATCH 04/10] mtd: rawnand: Fix comments about the use of bufpoi

[Boris Brezillon <boris.brezillon@xxxxxxxxxxxxx>]

On Fri, 24 Apr 2020 19:36:25 +0200
Miquel Raynal <miquel.raynal@xxxxxxxxxxx> wrote:

> Clarify these comments which are not very accurate (even wrong in the
> read case).
> 
> Signed-off-by: Miquel Raynal <miquel.raynal@xxxxxxxxxxx>

Reviewed-by: Boris Brezillon <boris.brezillon@xxxxxxxxxxxxx>

> ---
>  drivers/mtd/nand/raw/nand_base.c | 10 ++++++++--
>  1 file changed, 8 insertions(+), 2 deletions(-)
> 
> diff --git a/drivers/mtd/nand/raw/nand_base.c b/drivers/mtd/nand/raw/nand_base.c
> index db2745cf4f15..4d8a4a20df63 100644
> --- a/drivers/mtd/nand/raw/nand_base.c
> +++ b/drivers/mtd/nand/raw/nand_base.c
> @@ -3229,7 +3229,10 @@ static int nand_do_read_ops(struct nand_chip *chip, loff_t from,
>  				break;
>  			}
>  
> -			/* Transfer not aligned data */
> +			/*
> +			 * Copy back the data in the initial buffer when reading
> +			 * partial pages or when a bounce buffer is required.
> +			 */
>  			if (use_bufpoi) {
>  				if (!NAND_HAS_SUBPAGE_READ(chip) && !oob &&
>  				    !(mtd->ecc_stats.failed - ecc_failures) &&
> @@ -4024,7 +4027,10 @@ static int nand_do_write_ops(struct nand_chip *chip, loff_t to,
>  		else
>  			use_bufpoi = 0;
>  
> -		/* Partial page write?, or need to use bounce buffer */
> +		/*
> +		 * Copy the data from the initial buffer when doing partial page
> +		 * writes or when a bounce buffer is required.
> +		 */
>  		if (use_bufpoi) {
>  			pr_debug("%s: using write bounce buffer for buf@%p\n",
>  					 __func__, buf);


______________________________________________________
Linux MTD discussion mailing list
http://lists.infradead.org/mailman/listinfo/linux-mtd/