[PATCH v2 1/6] mtd: rawnand: marvell: Fix the condition on a return code

[Miquel Raynal <miquel.raynal@xxxxxxxxxxx>]

In a previous fix, I changed the condition on which the timeout of an
IRQ is reached from:

    if (!ret)

into:

    if (ret && !pending)

While having a non-zero return code is usual in the Linux kernel, here
ret comes from a wait_for_completion_timeout() which returns 0 when
the waiting period is too long.

Hence, the revised condition should be:

    if (!ret && !pending)

The faulty patch did not produce any error because of the !pending
condition so this change is finally purely cosmetic and does not
change the actual driver behavior.

Fixes: cafb56dd741e ("mtd: rawnand: marvell: prevent timeouts on a loaded machine")
Signed-off-by: Miquel Raynal <miquel.raynal@xxxxxxxxxxx>
Reviewed-by: Boris Brezillon <boris.brezillon@xxxxxxxxxxxxx>
---
 drivers/mtd/nand/raw/marvell_nand.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/mtd/nand/raw/marvell_nand.c b/drivers/mtd/nand/raw/marvell_nand.c
index 179f0ca585f8..f2bf88336326 100644
--- a/drivers/mtd/nand/raw/marvell_nand.c
+++ b/drivers/mtd/nand/raw/marvell_nand.c
@@ -707,7 +707,7 @@ static int marvell_nfc_wait_op(struct nand_chip *chip, unsigned int timeout_ms)
 	 * In case the interrupt was not served in the required time frame,
 	 * check if the ISR was not served or if something went actually wrong.
 	 */
-	if (ret && !pending) {
+	if (!ret && !pending) {
 		dev_err(nfc->dev, "Timeout waiting for RB signal\n");
 		return -ETIMEDOUT;
 	}
-- 
2.20.1


______________________________________________________
Linux MTD discussion mailing list
http://lists.infradead.org/mailman/listinfo/linux-mtd/