[PATCH v3 1/4] spi: make spi-max-frequency optional

[Chuanhong Guo <gch981213@xxxxxxxxx>]

We only need a spi-max-frequency when we specifically request a
spi frequency lower than the max speed of spi host.
This property is already documented as optional property and current
host drivers are implemented to operate at highest speed possible
when spi->max_speed_hz is 0.
This patch makes spi-max-frequency an optional property so that
we could just omit it to use max controller speed.

Signed-off-by: Chuanhong Guo <gch981213@xxxxxxxxx>
---
Change since v2:
 none

Change since v1:
 new patch

 drivers/spi/spi.c | 9 ++-------
 1 file changed, 2 insertions(+), 7 deletions(-)

diff --git a/drivers/spi/spi.c b/drivers/spi/spi.c
index 22baf204a09d..e317fb30329f 100644
--- a/drivers/spi/spi.c
+++ b/drivers/spi/spi.c
@@ -1951,13 +1951,8 @@ static int of_spi_parse_dt(struct spi_controller *ctlr, struct spi_device *spi,
 		spi->mode |= SPI_CS_HIGH;
 
 	/* Device speed */
-	rc = of_property_read_u32(nc, "spi-max-frequency", &value);
-	if (rc) {
-		dev_err(&ctlr->dev,
-			"%pOF has no valid 'spi-max-frequency' property (%d)\n", nc, rc);
-		return rc;
-	}
-	spi->max_speed_hz = value;
+	if (!of_property_read_u32(nc, "spi-max-frequency", &value))
+		spi->max_speed_hz = value;
 
 	return 0;
 }
-- 
2.24.1


______________________________________________________
Linux MTD discussion mailing list
http://lists.infradead.org/mailman/listinfo/linux-mtd/