[PATCH v2 2/2] mtd: rawnand: gpmi: Restore nfc timing setup after suspend/resume

[Esben Haabendal <esben@xxxxxxxxxx>]

As we reset the GPMI block at resume, the timing parameters setup by a
previous exec_op is lost.  Rewriting GPMI timing registers on first exec_op
after resume fixes the problem.

Fixes: ef347c0cfd61 ("mtd: rawnand: gpmi: Implement exec_op")
Cc: stable@xxxxxxxxxxxxxxx
Signed-off-by: Esben Haabendal <esben@xxxxxxxxxx>
---
 drivers/mtd/nand/raw/gpmi-nand/gpmi-nand.c | 4 ++++
 1 file changed, 4 insertions(+)

diff --git a/drivers/mtd/nand/raw/gpmi-nand/gpmi-nand.c b/drivers/mtd/nand/raw/gpmi-nand/gpmi-nand.c
index 879df8402446..b9d5d55a5edb 100644
--- a/drivers/mtd/nand/raw/gpmi-nand/gpmi-nand.c
+++ b/drivers/mtd/nand/raw/gpmi-nand/gpmi-nand.c
@@ -2727,6 +2727,10 @@ static int gpmi_pm_resume(struct device *dev)
 		return ret;
 	}
 
+	/* Set flag to get timing setup restored for next exec_op */
+	if (this->hw.clk_rate)
+		this->hw.must_apply_timings = true;
+
 	/* re-init the BCH registers */
 	ret = bch_set_geometry(this);
 	if (ret) {
-- 
2.25.0


______________________________________________________
Linux MTD discussion mailing list
http://lists.infradead.org/mailman/listinfo/linux-mtd/