Hi Michael, [...] >>> +- no-unlock : By default, linux unlocks the whole flash because there >>> + are legacy flash devices which are locked by default >>> + after reset. Set this flag if you don't want linux to >>> + unlock the whole flash automatically. In this case you >>> + can control the non-volatile bits by the >>> + flash_lock/flash_unlock tools. >>> >> >> Current SPI NOR framework unconditionally unlocks entire flash which >> I agree is not the best thing to do, but I don't think we need >> new DT property here. MTD cmdline partitions and DT partitions already >> provide a way to specify that a partition should remain locked[1][2] > > I know that the MTD layer has the same kind of unlocking. But that > unlocking is done on a per mtd partition basis. Eg. consider something > like the following > > mtd1 bootloader (locked) > mtd2 firmware (locked) > mtd3 kernel > mtd4 environment > > Further assume, that the end of mtd2 aligns with one of the possible > locking areas which are supported by the flash chip. Eg. the first quarter. > > The mtd layer would do two (or four, if "lock" property is set) unlock() > calls, one for mtd1 and one for mtd2. > > My point here is, that the mtd partitions doesn't always map to the > locking regions of the SPI flash (at least if the are not merged together). > You are right! This will be an issue if existing partitions are not aligned to locking regions. I take my comments back... But I am not sure if a new DT property is the needed. This does not describe HW and is specific to Linux SPI NOR stack. How about a module parameter instead? Module parameter won't provide per flash granularity in controlling unlocking behavior. But I don't think that matters. Tudor, You had a patch doing something similar. Does module param sound good to you? -- Regards Vignesh ______________________________________________________ Linux MTD discussion mailing list http://lists.infradead.org/mailman/listinfo/linux-mtd/