Hello, +Russell who might have thoughts about the issue Miquel Raynal <miquel.raynal@xxxxxxxxxxx> wrote on Fri, 18 Oct 2019 16:36:43 +0200: > Any write with either dd or flashcp to a device driven by the > spear_smi.c driver will pass through the spear_smi_cpy_toio() > function. This function will get called for chunks of up to 256 bytes. > If the amount of data is smaller, we may have a problem if the data > length is not 4-byte aligned. In this situation, the kernel panics > during the memcpy: > > # dd if=/dev/urandom bs=1001 count=1 of=/dev/mtd6 > spear_smi_cpy_toio [620] dest c9070000, src c7be8800, len 256 > spear_smi_cpy_toio [620] dest c9070100, src c7be8900, len 256 > spear_smi_cpy_toio [620] dest c9070200, src c7be8a00, len 256 > spear_smi_cpy_toio [620] dest c9070300, src c7be8b00, len 233 > Unhandled fault: external abort on non-linefetch (0x808) at 0xc90703e8 > [...] > PC is at memcpy+0xcc/0x330 > > Workaround this issue by using the alternate _memcpy_toio() method > which at least does not present the same problem. > > Fixes: f18dbbb1bfe0 ("mtd: ST SPEAr: Add SMI driver for serial NOR flash") > Cc: stable@xxxxxxxxxxxxxxx > Suggested-by: Boris Brezillon <boris.brezillon@xxxxxxxxxxxxx> > Signed-off-by: Miquel Raynal <miquel.raynal@xxxxxxxxxxx> > --- > > Hello, > > This patch could not be tested with a mainline kernel (only compiled) > but was tested with a stable 4.14.x kernel. I have really no idea why > memcpy fails in this situation that's why I propose this workaround > but I bet there is something deeper not working. I did not mention that the opposite direction using memcpy_fromio() does not present any issue. > > Thanks, > Miquèl > > drivers/mtd/devices/spear_smi.c | 2 +- > 1 file changed, 1 insertion(+), 1 deletion(-) > > diff --git a/drivers/mtd/devices/spear_smi.c b/drivers/mtd/devices/spear_smi.c > index 986f81d2f93e..d888625a3244 100644 > --- a/drivers/mtd/devices/spear_smi.c > +++ b/drivers/mtd/devices/spear_smi.c > @@ -614,7 +614,7 @@ static inline int spear_smi_cpy_toio(struct spear_smi *dev, u32 bank, > ctrlreg1 = readl(dev->io_base + SMI_CR1); > writel((ctrlreg1 | WB_MODE) & ~SW_MODE, dev->io_base + SMI_CR1); > > - memcpy_toio(dest, src, len); > + _memcpy_toio(dest, src, len); > > writel(ctrlreg1, dev->io_base + SMI_CR1); > Thanks, Miquèl ______________________________________________________ Linux MTD discussion mailing list http://lists.infradead.org/mailman/listinfo/linux-mtd/