[PATCH 01/16] mtd: spi-nor: aspeed: Use command mode for reads

[Cédric Le Goater <clg@xxxxxxxx>]

When reading flash contents, try to read from the AHB window
configured for the flash module. This is called the "command mode" on
Aspeed SoC SMC controllers. If the window is not big enough, because
of HW issues, fall back to the "user mode" to perform the read.

Signed-off-by: Cédric Le Goater <clg@xxxxxxxx>
---
 drivers/mtd/spi-nor/aspeed-smc.c | 28 +++++++++++++++++++++++++++-
 1 file changed, 27 insertions(+), 1 deletion(-)

diff --git a/drivers/mtd/spi-nor/aspeed-smc.c b/drivers/mtd/spi-nor/aspeed-smc.c
index 009c1da8574c..148bbc934efc 100644
--- a/drivers/mtd/spi-nor/aspeed-smc.c
+++ b/drivers/mtd/spi-nor/aspeed-smc.c
@@ -398,6 +398,31 @@ static ssize_t aspeed_smc_write_user(struct spi_nor *nor, loff_t to,
 	return len;
 }
 
+static ssize_t aspeed_smc_read(struct spi_nor *nor, loff_t from, size_t len,
+			       u_char *read_buf)
+{
+	struct aspeed_smc_chip *chip = nor->priv;
+
+	/*
+	 * The AHB window configured for the chip is too small for the
+	 * read offset. Use the "User mode" of the controller to
+	 * perform the read.
+	 */
+	if (from >= chip->ahb_window_size) {
+		aspeed_smc_read_user(nor, from, len, read_buf);
+		goto out;
+	}
+
+	/*
+	 * Use the "Command mode" to do a direct read from the AHB
+	 * window configured for the chip. This should be the default.
+	 */
+	memcpy_fromio(read_buf, chip->ahb_base + from, len);
+
+out:
+	return len;
+}
+
 static int aspeed_smc_unregister(struct aspeed_smc_controller *controller)
 {
 	struct aspeed_smc_chip *chip;
@@ -739,6 +764,7 @@ static int aspeed_smc_chip_setup_finish(struct aspeed_smc_chip *chip)
 	}
 
 	chip->ctl_val[smc_read] |= cmd |
+		chip->nor.read_opcode << CONTROL_COMMAND_SHIFT |
 		CONTROL_IO_DUMMY_SET(chip->nor.read_dummy / 8);
 
 	dev_dbg(controller->dev, "base control register: %08x\n",
@@ -805,7 +831,7 @@ static int aspeed_smc_setup_flash(struct aspeed_smc_controller *controller,
 		nor->dev = dev;
 		nor->priv = chip;
 		spi_nor_set_flash_node(nor, child);
-		nor->read = aspeed_smc_read_user;
+		nor->read = aspeed_smc_read;
 		nor->write = aspeed_smc_write_user;
 		nor->read_reg = aspeed_smc_read_reg;
 		nor->write_reg = aspeed_smc_write_reg;
-- 
2.21.0


______________________________________________________
Linux MTD discussion mailing list
http://lists.infradead.org/mailman/listinfo/linux-mtd/