From: Boris Brezillon <boris.brezillon@xxxxxxxxxxx> The spi-mem layer provides a spi_mem_supports_op() function to check whether a specific operation is supported by the controller or not. This is much more accurate than the hwcaps selection logic based on SPI_{RX,TX}_ flags. Rework the hwcaps selection logic to use spi_mem_supports_op() when nor->spimem != NULL. Signed-off-by: Boris Brezillon <boris.brezillon@xxxxxxxxxxx> Signed-off-by: Vignesh Raghavendra <vigneshr@xxxxxx> --- drivers/mtd/spi-nor/spi-nor.c | 183 +++++++++++++++++++++++++++------- include/linux/mtd/spi-nor.h | 14 +++ 2 files changed, 161 insertions(+), 36 deletions(-) diff --git a/drivers/mtd/spi-nor/spi-nor.c b/drivers/mtd/spi-nor/spi-nor.c index 4fae7f92715a..2590d82982e8 100644 --- a/drivers/mtd/spi-nor/spi-nor.c +++ b/drivers/mtd/spi-nor/spi-nor.c @@ -2952,6 +2952,129 @@ static int spi_nor_read_sfdp(struct spi_nor *nor, u32 addr, return ret; } +/** + * spi_nor_spimem_check_op - check if the operation is supported + * by controller + *@nor: pointer to a 'struct spi_nor' + *@op: pointer to op template to be checked + * + * Returns 0 if operation is supported, -ENOTSUPP otherwise. + */ +static int spi_nor_spimem_check_op(struct spi_nor *nor, + struct spi_mem_op *op) +{ + /* + * First test with 4 address bytes. The opcode itself might + * be a 3B addressing opcode but we don't care, because + * SPI controller implementation should not check the opcode, + * but just the sequence. + */ + op->addr.nbytes = 4; + if (!spi_mem_supports_op(nor->spimem, op)) { + /* If flash size <16MB, 3 address bytes are sufficient */ + if (nor->mtd.size <= SZ_16M) { + op->addr.nbytes = 3; + if (!spi_mem_supports_op(nor->spimem, op)) + return -ENOTSUPP; + } + } + + return 0; +} + +/** + * spi_nor_spimem_check_readop - check if the read op is supported + * by controller + *@nor: pointer to a 'struct spi_nor' + *@read: pointer to op template to be checked + * + * Returns 0 if operation is supported, -ENOTSUPP otherwise. + */ +static int spi_nor_spimem_check_readop(struct spi_nor *nor, + const struct spi_nor_read_command *read) +{ + struct spi_mem_op op = SPI_MEM_OP(SPI_MEM_OP_CMD(read->opcode, 1), + SPI_MEM_OP_ADDR(3, 0, 1), + SPI_MEM_OP_DUMMY(0, 1), + SPI_MEM_OP_DATA_IN(0, NULL, 1)); + + op.cmd.buswidth = spi_nor_get_protocol_inst_nbits(read->proto); + op.addr.buswidth = spi_nor_get_protocol_addr_nbits(read->proto); + op.data.buswidth = spi_nor_get_protocol_data_nbits(read->proto); + op.dummy.buswidth = op.addr.buswidth; + op.dummy.nbytes = (read->num_mode_clocks + read->num_wait_states) * + op.dummy.buswidth / 8; + + return spi_nor_spimem_check_op(nor, &op); +} + +/** + * spi_nor_spimem_check_pp - check if the page program op is supported + * by controller + *@nor: pointer to a 'struct spi_nor' + *@pp: pointer to op template to be checked + * + * Returns 0 if operation is supported, -ENOTSUPP otherwise. + */ +static int spi_nor_spimem_check_pp(struct spi_nor *nor, + const struct spi_nor_pp_command *pp) +{ + struct spi_mem_op op = SPI_MEM_OP(SPI_MEM_OP_CMD(pp->opcode, 1), + SPI_MEM_OP_ADDR(3, 0, 1), + SPI_MEM_OP_NO_DUMMY, + SPI_MEM_OP_DATA_OUT(0, NULL, 1)); + + op.cmd.buswidth = spi_nor_get_protocol_inst_nbits(pp->proto); + op.addr.buswidth = spi_nor_get_protocol_addr_nbits(pp->proto); + op.data.buswidth = spi_nor_get_protocol_data_nbits(pp->proto); + + return spi_nor_spimem_check_op(nor, &op); +} + +/** + * spi_nor_spimem_adjust_hwcaps - Find optimal Read/Write protocol + * based on SPI controller capabilities + * @nor: pointer to a 'struct spi_nor' + * @params: pointer to the 'struct spi_nor_flash_parameter' + * representing SPI NOR flash capabilities + * @hwcaps: pointer to resulting capabilities after adjusting + * according to controller and flash's capability + */ +static void +spi_nor_spimem_adjust_hwcaps(struct spi_nor *nor, + const struct spi_nor_flash_parameter *params, + u32 *hwcaps) +{ + unsigned int cap; + + /* DTR modes are not supported yet, mask them all. */ + *hwcaps &= ~SNOR_HWCAPS_DTR; + + /* X-X-X modes are not supported yet, mask them all. */ + *hwcaps &= ~SNOR_HWCAPS_X_X_X; + + /* Start with read commands. */ + for (cap = 0; cap < sizeof(*hwcaps) * BITS_PER_BYTE; cap++) { + int rdidx, ppidx; + + if (!(*hwcaps & BIT(cap))) + continue; + + rdidx = spi_nor_hwcaps_read2cmd(BIT(cap)); + if (rdidx >= 0 && + spi_nor_spimem_check_readop(nor, ¶ms->reads[rdidx])) + *hwcaps &= ~BIT(cap); + + ppidx = spi_nor_hwcaps_pp2cmd(BIT(cap)); + if (ppidx < 0) + continue; + + if (spi_nor_spimem_check_pp(nor, + ¶ms->page_programs[ppidx])) + *hwcaps &= ~BIT(cap); + } +} + /** * spi_nor_read_sfdp_dma_unsafe() - read Serial Flash Discoverable Parameters. * @nor: pointer to a 'struct spi_nor' @@ -4361,16 +4484,25 @@ static int spi_nor_setup(struct spi_nor *nor, */ shared_mask = hwcaps->mask & params->hwcaps.mask; - /* SPI n-n-n protocols are not supported yet. */ - ignored_mask = (SNOR_HWCAPS_READ_2_2_2 | - SNOR_HWCAPS_READ_4_4_4 | - SNOR_HWCAPS_READ_8_8_8 | - SNOR_HWCAPS_PP_4_4_4 | - SNOR_HWCAPS_PP_8_8_8); - if (shared_mask & ignored_mask) { - dev_dbg(nor->dev, - "SPI n-n-n protocols are not supported yet.\n"); - shared_mask &= ~ignored_mask; + if (nor->spimem) { + /* + * When called from spi_nor_probe(), all caps are set and we + * need to discard some of them based on what the SPI + * controller actually supports (using spi_mem_supports_op()). + */ + spi_nor_spimem_adjust_hwcaps(nor, params, &shared_mask); + } else { + /* + * SPI n-n-n protocols are not supported when the SPI + * controller directly implements the spi_nor interface. + * Yet another reason to switch to spi-mem. + */ + ignored_mask = SNOR_HWCAPS_X_X_X; + if (shared_mask & ignored_mask) { + dev_dbg(nor->dev, + "SPI n-n-n protocols are not supported.\n"); + shared_mask &= ~ignored_mask; + } } /* Select the (Fast) Read command. */ @@ -4709,11 +4841,11 @@ static int spi_nor_probe(struct spi_mem *spimem) struct spi_device *spi = spimem->spi; struct flash_platform_data *data = dev_get_platdata(&spi->dev); struct spi_nor *nor; - struct spi_nor_hwcaps hwcaps = { - .mask = SNOR_HWCAPS_READ | - SNOR_HWCAPS_READ_FAST | - SNOR_HWCAPS_PP, - }; + /* + * Enable all caps by default. The core will mask them after + * checking what's really supported using spi_mem_supports_op(). + */ + const struct spi_nor_hwcaps hwcaps = { .mask = SNOR_HWCAPS_ALL }; char *flash_name; int ret; @@ -4727,27 +4859,6 @@ static int spi_nor_probe(struct spi_mem *spimem) spi_mem_set_drvdata(spimem, nor); - if (spi->mode & SPI_RX_OCTAL) { - hwcaps.mask |= SNOR_HWCAPS_READ_1_1_8; - - if (spi->mode & SPI_TX_OCTAL) - hwcaps.mask |= (SNOR_HWCAPS_READ_1_8_8 | - SNOR_HWCAPS_PP_1_1_8 | - SNOR_HWCAPS_PP_1_8_8); - } else if (spi->mode & SPI_RX_QUAD) { - hwcaps.mask |= SNOR_HWCAPS_READ_1_1_4; - - if (spi->mode & SPI_TX_QUAD) - hwcaps.mask |= (SNOR_HWCAPS_READ_1_4_4 | - SNOR_HWCAPS_PP_1_1_4 | - SNOR_HWCAPS_PP_1_4_4); - } else if (spi->mode & SPI_RX_DUAL) { - hwcaps.mask |= SNOR_HWCAPS_READ_1_1_2; - - if (spi->mode & SPI_TX_DUAL) - hwcaps.mask |= SNOR_HWCAPS_READ_1_2_2; - } - if (data && data->name) nor->mtd.name = data->name; diff --git a/include/linux/mtd/spi-nor.h b/include/linux/mtd/spi-nor.h index 4f35b1877889..5f1acb1867dd 100644 --- a/include/linux/mtd/spi-nor.h +++ b/include/linux/mtd/spi-nor.h @@ -524,6 +524,20 @@ struct spi_nor_hwcaps { #define SNOR_HWCAPS_PP_1_8_8 BIT(21) #define SNOR_HWCAPS_PP_8_8_8 BIT(22) +#define SNOR_HWCAPS_X_X_X (SNOR_HWCAPS_READ_2_2_2 | \ + SNOR_HWCAPS_READ_4_4_4 | \ + SNOR_HWCAPS_READ_8_8_8 | \ + SNOR_HWCAPS_PP_4_4_4 | \ + SNOR_HWCAPS_PP_8_8_8) + +#define SNOR_HWCAPS_DTR (SNOR_HWCAPS_READ_1_1_1_DTR | \ + SNOR_HWCAPS_READ_1_2_2_DTR | \ + SNOR_HWCAPS_READ_1_4_4_DTR | \ + SNOR_HWCAPS_READ_1_8_8_DTR) + +#define SNOR_HWCAPS_ALL (SNOR_HWCAPS_READ_MASK | \ + SNOR_HWCAPS_PP_MASK) + /** * spi_nor_scan() - scan the SPI NOR * @nor: the spi_nor structure -- 2.22.0 ______________________________________________________ Linux MTD discussion mailing list http://lists.infradead.org/mailman/listinfo/linux-mtd/