[PATCH 3/5] mtd: spi-nor: add Global Block Unlock support

[<Tudor.Ambarus@xxxxxxxxxxxxx>]

From: Tudor Ambarus <tudor.ambarus@xxxxxxxxxxxxx>

To avoid inadvertent writes during power-up, some flashes are
write-protected by default after a power-on reset cycle.
A Global Block-Protection Unlock command offers a single
command cycle that unlocks the entire memory array. This is
identical with what other nor flashes are doing by clearing
the block protection bits from the status register: disable
the write protection after a power-on reset cycle.

We can't determine this purely by manufacturer type and it's not
autodetectable by anything like SFDP, so make a new flag for it:
UNLOCK_GLOBAL_BLOCK.

Note that the Global Block Unlock command has different names
depending on the manufacturer, but always the same command value:
0x98. Macronix's MX25U12835F names it Gang Block Unlock,
Winbound's W25Q128FV names it Global Block Unlock and
Microchip's SST26VF064B names it Global Block Protection Unlock.

Signed-off-by: Tudor Ambarus <tudor.ambarus@xxxxxxxxxxxxx>
---
 drivers/mtd/spi-nor/spi-nor.c | 21 ++++++++++++++++++++-
 include/linux/mtd/spi-nor.h   |  1 +
 2 files changed, 21 insertions(+), 1 deletion(-)

diff --git a/drivers/mtd/spi-nor/spi-nor.c b/drivers/mtd/spi-nor/spi-nor.c
index e9e441f91b68..767e2e6eb1b8 100644
--- a/drivers/mtd/spi-nor/spi-nor.c
+++ b/drivers/mtd/spi-nor/spi-nor.c
@@ -250,7 +250,7 @@ struct flash_info {
 	u16		page_size;
 	u16		addr_width;
 
-	u16		flags;
+	u32		flags;
 #define SECT_4K			BIT(0)	/* SPINOR_OP_BE_4K works uniformly */
 #define SPI_NOR_NO_ERASE	BIT(1)	/* No erase command needed */
 #define SST_WRITE		BIT(2)	/* use SST byte programming */
@@ -279,6 +279,7 @@ struct flash_info {
 #define SPI_NOR_SKIP_SFDP	BIT(13)	/* Skip parsing of SFDP tables */
 #define USE_CLSR		BIT(14)	/* use CLSR command */
 #define SPI_NOR_OCTAL_READ	BIT(15)	/* Flash supports Octal Read */
+#define UNLOCK_GLOBAL_BLOCK	BIT(16) /* Unlock global block protection */
 
 	/* Part specific fixup hooks. */
 	const struct spi_nor_fixups *fixups;
@@ -1725,6 +1726,20 @@ static int spi_nor_spansion_clear_sr_bp(struct spi_nor *nor)
 	return spi_nor_clear_sr_bp(nor);
 }
 
+static int spi_nor_unlock_global_block_protection(struct spi_nor *nor)
+{
+	int ret;
+
+	write_enable(nor);
+
+	ret = nor->write_reg(nor, SPINOR_OP_ULBPR, NULL, 0);
+	if (ret < 0) {
+		dev_err(nor->dev, "error %d on ULBPR\n", ret);
+		return ret;
+	}
+	return spi_nor_wait_till_ready(nor);
+}
+
 /* Used when the "_ext_id" is two bytes at most */
 #define INFO(_jedec_id, _ext_id, _sector_size, _n_sectors, _flags)	\
 		.id = {							\
@@ -4053,6 +4068,10 @@ static int spi_nor_init(struct spi_nor *nor)
 				spi_nor_spansion_clear_sr_bp;
 	}
 
+	if (nor->info->flags & UNLOCK_GLOBAL_BLOCK)
+		nor->disable_write_protection =
+			spi_nor_unlock_global_block_protection;
+
 	if (nor->disable_write_protection) {
 		err = nor->disable_write_protection(nor);
 		if (err) {
diff --git a/include/linux/mtd/spi-nor.h b/include/linux/mtd/spi-nor.h
index 6c3273760700..84d279fd287e 100644
--- a/include/linux/mtd/spi-nor.h
+++ b/include/linux/mtd/spi-nor.h
@@ -65,6 +65,7 @@
 #define SPINOR_OP_CLFSR		0x50	/* Clear flag status register */
 #define SPINOR_OP_RDEAR		0xc8	/* Read Extended Address Register */
 #define SPINOR_OP_WREAR		0xc5	/* Write Extended Address Register */
+#define SPINOR_OP_ULBPR		0x98    /* Global Block Unlock Protection */
 
 /* 4-byte address opcodes - used on Spansion and some Macronix flashes. */
 #define SPINOR_OP_READ_4B	0x13	/* Read data bytes (low frequency) */
-- 
2.9.5


______________________________________________________
Linux MTD discussion mailing list
http://lists.infradead.org/mailman/listinfo/linux-mtd/