On Fri, May 3, 2019 at 12:00 PM Marek Vasut <marek.vasut@xxxxxxxxx> wrote: > > On 5/3/19 10:53 AM, Simon Goldschmidt wrote: > > Tested on socfpga cyclone5 where this is required to ensure that the > > boot rom can access this flash after warm reboot. > > Are you sure _all_ variants of the N25Q256 support 4NB opcodes ? > I think there were some which didn't, but I might be wrong. Oh, damn, you're right. The documentation [1] statest that 4-byte erase and program opcodes are only supported for part numbers N25Q256A83ESF40x, N25Q256A83E1240x and N25QA83ESFA0F. Any idea of how I can still enable 4-byte opcodes for my chip? Regards, Simon > > > Signed-off-by: Simon Goldschmidt <simon.k.r.goldschmidt@xxxxxxxxx> > > --- > > > > drivers/mtd/spi-nor/spi-nor.c | 2 +- > > 1 file changed, 1 insertion(+), 1 deletion(-) > > > > diff --git a/drivers/mtd/spi-nor/spi-nor.c b/drivers/mtd/spi-nor/spi-nor.c > > index fae147452..4cdec2cc2 100644 > > --- a/drivers/mtd/spi-nor/spi-nor.c > > +++ b/drivers/mtd/spi-nor/spi-nor.c > > @@ -1874,7 +1874,7 @@ static const struct flash_info spi_nor_ids[] = { > > { "n25q064a", INFO(0x20bb17, 0, 64 * 1024, 128, SECT_4K | SPI_NOR_QUAD_READ) }, > > { "n25q128a11", INFO(0x20bb18, 0, 64 * 1024, 256, SECT_4K | SPI_NOR_QUAD_READ) }, > > { "n25q128a13", INFO(0x20ba18, 0, 64 * 1024, 256, SECT_4K | SPI_NOR_QUAD_READ) }, > > - { "n25q256a", INFO(0x20ba19, 0, 64 * 1024, 512, SECT_4K | SPI_NOR_DUAL_READ | SPI_NOR_QUAD_READ) }, > > + { "n25q256a", INFO(0x20ba19, 0, 64 * 1024, 512, SECT_4K | SPI_NOR_DUAL_READ | SPI_NOR_QUAD_READ | SPI_NOR_4B_OPCODES) }, > > { "n25q256ax1", INFO(0x20bb19, 0, 64 * 1024, 512, SECT_4K | SPI_NOR_QUAD_READ) }, > > { "n25q512a", INFO(0x20bb20, 0, 64 * 1024, 1024, SECT_4K | USE_FSR | SPI_NOR_QUAD_READ) }, > > { "n25q512ax3", INFO(0x20ba20, 0, 64 * 1024, 1024, SECT_4K | USE_FSR | SPI_NOR_QUAD_READ) }, > > > > ______________________________________________________ Linux MTD discussion mailing list http://lists.infradead.org/mailman/listinfo/linux-mtd/