Add direct mapping read mode for Macronix SPI controller driver. Signed-off-by: Mason Yang <masonccyang@xxxxxxxxxxx> --- drivers/spi/spi-mxic.c | 129 ++++++++++++++++++++++++++++++++++++++----------- 1 file changed, 100 insertions(+), 29 deletions(-) diff --git a/drivers/spi/spi-mxic.c b/drivers/spi/spi-mxic.c index fbebf89..9f5ff2b 100644 --- a/drivers/spi/spi-mxic.c +++ b/drivers/spi/spi-mxic.c @@ -19,6 +19,7 @@ struct mxic_spi { struct clk *send_clk; struct clk *send_dly_clk; void __iomem *regs; + void __iomem *dirmap; u32 cur_speed_hz; }; @@ -128,6 +129,42 @@ static void mxic_spi_hw_init(struct mxic_spi *mxic) mxic->regs + HC_CFG); } +static u32 mxic_spi_mem_prep_op_cfg(const struct spi_mem_op *op) +{ + u32 cfg = OP_CMD_BYTES(1) | OP_CMD_BUSW(fls(op->cmd.buswidth) - 1); + + if (op->addr.nbytes) + cfg |= OP_ADDR_BYTES(op->addr.nbytes) | + OP_ADDR_BUSW(fls(op->addr.buswidth) - 1); + + if (op->dummy.nbytes) + cfg |= OP_DUMMY_CYC(op->dummy.nbytes); + + if (op->data.nbytes) { + cfg |= OP_DATA_BUSW(fls(op->data.buswidth) - 1); + if (op->data.dir == SPI_MEM_DATA_IN) + cfg |= OP_READ; + } + + return cfg; +} + +static void mxic_spi_set_hc_cfg(struct spi_device *spi, u32 flags) +{ + struct mxic_spi *mxic = spi_master_get_devdata(spi->master); + int nio = 1; + + if (spi->mode & (SPI_TX_QUAD | SPI_RX_QUAD)) + nio = 4; + else if (spi->mode & (SPI_TX_DUAL | SPI_RX_DUAL)) + nio = 2; + + writel(flags | HC_CFG_NIO(nio) | + HC_CFG_TYPE(spi->chip_select, HC_CFG_TYPE_SPI_NOR) | + HC_CFG_SLV_ACT(spi->chip_select) | HC_CFG_IDLE_SIO_LVL(1), + mxic->regs + HC_CFG); +} + static int mxic_spi_data_xfer(struct mxic_spi *mxic, const void *txbuf, void *rxbuf, unsigned int len) { @@ -201,43 +238,18 @@ static int mxic_spi_mem_exec_op(struct spi_mem *mem, const struct spi_mem_op *op) { struct mxic_spi *mxic = spi_master_get_devdata(mem->spi->master); - int nio = 1, i, ret; - u32 ss_ctrl; + int i, ret; u8 addr[8]; ret = mxic_spi_set_freq(mxic, mem->spi->max_speed_hz); if (ret) return ret; - if (mem->spi->mode & (SPI_TX_QUAD | SPI_RX_QUAD)) - nio = 4; - else if (mem->spi->mode & (SPI_TX_DUAL | SPI_RX_DUAL)) - nio = 2; + mxic_spi_set_hc_cfg(mem->spi, HC_CFG_MAN_CS_EN); - writel(HC_CFG_NIO(nio) | - HC_CFG_TYPE(mem->spi->chip_select, HC_CFG_TYPE_SPI_NOR) | - HC_CFG_SLV_ACT(mem->spi->chip_select) | HC_CFG_IDLE_SIO_LVL(1) | - HC_CFG_MAN_CS_EN, - mxic->regs + HC_CFG); writel(HC_EN_BIT, mxic->regs + HC_EN); - - ss_ctrl = OP_CMD_BYTES(1) | OP_CMD_BUSW(fls(op->cmd.buswidth) - 1); - - if (op->addr.nbytes) - ss_ctrl |= OP_ADDR_BYTES(op->addr.nbytes) | - OP_ADDR_BUSW(fls(op->addr.buswidth) - 1); - - if (op->dummy.nbytes) - ss_ctrl |= OP_DUMMY_CYC(op->dummy.nbytes); - - if (op->data.nbytes) { - ss_ctrl |= OP_DATA_BUSW(fls(op->data.buswidth) - 1); - if (op->data.dir == SPI_MEM_DATA_IN) - ss_ctrl |= OP_READ; - } - - writel(ss_ctrl, mxic->regs + SS_CTRL(mem->spi->chip_select)); - + writel(mxic_spi_mem_prep_op_cfg(op), + mxic->regs + SS_CTRL(mem->spi->chip_select)); writel(readl(mxic->regs + HC_CFG) | HC_CFG_MAN_CS_ASSERT, mxic->regs + HC_CFG); @@ -271,9 +283,64 @@ static int mxic_spi_mem_exec_op(struct spi_mem *mem, return ret; } +static int mxic_spi_mem_dirmap_create(struct spi_mem_dirmap_desc *desc) +{ + struct mxic_spi *mxic = spi_master_get_devdata(desc->mem->spi->master); + + if (!mxic->dirmap) + return -ENOTSUPP; + + /* + * TODO: overcome this limitation by moving LWR/LRD_ADDR during a + * read/write operation. + */ + if (desc->info.offset + desc->info.length > U32_MAX) + return -ENOTSUPP; + + if (!mxic_spi_mem_supports_op(desc->mem, &desc->info.op_tmpl)) + return -ENOTSUPP; + + if (desc->info.op_tmpl.data.dir == SPI_MEM_DATA_OUT) + return -ENOTSUPP; + + return 0; +} + +static ssize_t mxic_spi_mem_dirmap_read(struct spi_mem_dirmap_desc *desc, + u64 offs, size_t len, void *buf) +{ + struct mxic_spi *mxic = spi_master_get_devdata(desc->mem->spi->master); + int ret; + u32 sts; + + mxic_spi_set_hc_cfg(desc->mem->spi, 0); + + writel(mxic_spi_mem_prep_op_cfg(&desc->info.op_tmpl), + mxic->regs + LRD_CFG); + writel(LMODE_CMD0(desc->info.op_tmpl.cmd.opcode >> 8) | + (LMODE_CMD1(desc->info.op_tmpl.cmd.opcode) & 0xff00) | + LMODE_SLV_ACT(desc->mem->spi->chip_select) | + LMODE_EN, mxic->regs + LRD_CTRL); + + memcpy_fromio(buf, mxic->dirmap + offs, len); + + writel(INT_LRD_DIS, mxic->regs + INT_STS); + writel(0, mxic->regs + LRD_CTRL); + + ret = readl_poll_timeout(mxic->regs + INT_STS, sts, + sts & INT_LRD_DIS, 0, USEC_PER_SEC); + + if (ret) + return ret; + + return len; +} + static const struct spi_controller_mem_ops mxic_spi_mem_ops = { .supports_op = mxic_spi_mem_supports_op, .exec_op = mxic_spi_mem_exec_op, + .dirmap_create = mxic_spi_mem_dirmap_create, + .dirmap_read = mxic_spi_mem_dirmap_read, }; static void mxic_spi_set_cs(struct spi_device *spi, bool lvl) @@ -404,6 +471,10 @@ static int mxic_spi_probe(struct platform_device *pdev) if (IS_ERR(mxic->regs)) return PTR_ERR(mxic->regs); + mxic->dirmap = mxic_mfd->dirmap; + if (IS_ERR(mxic->dirmap)) + mxic->dirmap = NULL; + pm_runtime_enable(&pdev->dev); master->auto_runtime_pm = true; -- 1.9.1 ______________________________________________________ Linux MTD discussion mailing list http://lists.infradead.org/mailman/listinfo/linux-mtd/