On Mon, Mar 4, 2019 at 10:50 AM, Miquel Raynal
<miquel.raynal@xxxxxxxxxxx> wrote:
Hi Paul,
Paul Cercueil <paul@xxxxxxxxxxxxxxx <mailto:paul@xxxxxxxxxxxxxxx>>
wrote on Sat, 9 Feb 2019 16:22:58
-0300:
The JZ4740 ECC hardware is not BCH but Reed-Solomon, so it makes
more
sense to use the more generic ECC term.
Signed-off-by: Paul Cercueil <paul@xxxxxxxxxxxxxxx
<mailto:paul@xxxxxxxxxxxxxxx>>
---
Changes:
v3: New patch
v4: No change
.../devicetree/bindings/mtd/ingenic,jz4780-nand.txt | 18
+++++++++---------
1 file changed, 9 insertions(+), 9 deletions(-)
diff --git
a/Documentation/devicetree/bindings/mtd/ingenic,jz4780-nand.txt
b/Documentation/devicetree/bindings/mtd/ingenic,jz4780-nand.txt
index a5b940f18bf6..5a45cc54f46d 100644
--- a/Documentation/devicetree/bindings/mtd/ingenic,jz4780-nand.txt
+++ b/Documentation/devicetree/bindings/mtd/ingenic,jz4780-nand.txt
@@ -1,4 +1,4 @@
-* Ingenic JZ4780 NAND/BCH
+* Ingenic JZ4780 NAND/ECC
This file documents the device tree bindings for NAND flash
devices on the
JZ4780. NAND devices are connected to the NEMC controller
(described in
@@ -14,10 +14,10 @@ Required NAND controller device properties:
an offset of 0 and a size of 0x1000000 (i.e. the whole NEMC
bank).
Optional NAND controller device properties:
-- ingenic,bch-controller: To make use of the hardware BCH
controller, this
- property must contain a phandle for the BCH controller node. The
required
+- ingenic,bch-controller: To make use of the hardware ECC
controller, this
+ property must contain a phandle for the ECC controller node. The
required
I think there is already a 'ecc-engine' property used by MTK and Atmel
NAND controllers to point to the ECC engine block. Please use this
property instead of the ingenic specific one.
ingenic,bch-controller is already in the devicetree ABI. I can't change
it now...
properties for this node are described below. If this is not
specified,
- software BCH will be used instead.
+ software ECC will be used instead.
Optional children nodes:
- Individual NAND chips are children of the NAND controller node.
@@ -70,17 +70,17 @@ nemc: nemc@13410000 {
};
};
-The BCH controller is a separate SoC component used for error
correction on
+The ECC controller is a separate SoC component used for error
correction on
NAND devices. The following is a description of the device
properties for a
-BCH controller.
+ECC controller.
-Required BCH properties:
+Required ECC properties:
- compatible: Should be one of:
* ingenic,jz4740-ecc
* ingenic,jz4725b-bch
* ingenic,jz4780-bch
-- reg: Should specify the BCH controller registers location and
length.
-- clocks: Clock for the BCH controller.
+- reg: Should specify the ECC controller registers location and
length.
+- clocks: Clock for the ECC controller.
Example:
Thanks,
Miquèl
______________________________________________________
Linux MTD discussion mailing list
http://lists.infradead.org/mailman/listinfo/linux-mtd/
