Use the runtime-detected denali->nbanks instead of hard-coded DENALI_NR_BANKS (=4). The actual number of banks depends on the IP configuration, and can be less than DENALI_NR_BANKS. It is pointless to touch registers of unsupported banks. Signed-off-by: Masahiro Yamada <yamada.masahiro@xxxxxxxxxxxxx> --- Changes in v2: None drivers/mtd/nand/raw/denali.c | 9 ++++----- 1 file changed, 4 insertions(+), 5 deletions(-) diff --git a/drivers/mtd/nand/raw/denali.c b/drivers/mtd/nand/raw/denali.c index a162bd1..eb58136 100644 --- a/drivers/mtd/nand/raw/denali.c +++ b/drivers/mtd/nand/raw/denali.c @@ -40,7 +40,6 @@ #define DENALI_BANK(denali) ((denali)->active_bank << 24) #define DENALI_INVALID_BANK -1 -#define DENALI_NR_BANKS 4 static struct denali_chip *to_denali_chip(struct nand_chip *chip) { @@ -92,7 +91,7 @@ static void denali_enable_irq(struct denali_controller *denali) { int i; - for (i = 0; i < DENALI_NR_BANKS; i++) + for (i = 0; i < denali->nbanks; i++) iowrite32(U32_MAX, denali->reg + INTR_EN(i)); iowrite32(GLOBAL_INT_EN_FLAG, denali->reg + GLOBAL_INT_ENABLE); } @@ -101,7 +100,7 @@ static void denali_disable_irq(struct denali_controller *denali) { int i; - for (i = 0; i < DENALI_NR_BANKS; i++) + for (i = 0; i < denali->nbanks; i++) iowrite32(0, denali->reg + INTR_EN(i)); iowrite32(0, denali->reg + GLOBAL_INT_ENABLE); } @@ -117,7 +116,7 @@ static void denali_clear_irq_all(struct denali_controller *denali) { int i; - for (i = 0; i < DENALI_NR_BANKS; i++) + for (i = 0; i < denali->nbanks; i++) denali_clear_irq(denali, i, U32_MAX); } @@ -130,7 +129,7 @@ static irqreturn_t denali_isr(int irq, void *dev_id) spin_lock(&denali->irq_lock); - for (i = 0; i < DENALI_NR_BANKS; i++) { + for (i = 0; i < denali->nbanks; i++) { irq_status = ioread32(denali->reg + INTR_STATUS(i)); if (irq_status) ret = IRQ_HANDLED; -- 2.7.4 ______________________________________________________ Linux MTD discussion mailing list http://lists.infradead.org/mailman/listinfo/linux-mtd/