Re: [PATCH v3 8/9] mtd: rawnand: ingenic: Add support for the JZ4725B

[Miquel Raynal <miquel.raynal@xxxxxxxxxxx>]

Hi Paul,


[...]

> >>  +
> >>  +static void jz4725b_bch_init(struct ingenic_ecc *bch,
> >>  +			     struct ingenic_ecc_params *params, bool encode)  
> > 
> > I don't know the IP but 'encode' looks strange, what is it supposed to
> > mean?  
> 
> It is used to toggle between calculating the ECC codes for a given set of data,
> and using supplied ECC codes to verify a set of data.
> 
> I just reused the function and parameter names that were used in the
> jz4780-bch driver, that's where the 'encode' comes from.


I see, so it is kind of a "derive" vs. "verify" information. Please
add a comment explaining the parameter name then.

> >>  +{
> >>  +	u32 reg;
> >>  +
> >>  +	/* Clear interrupt status. */
> >>  +	writel(readl(bch->base + BCH_BHINT), bch->base + BCH_BHINT);
> >>  +
> >>  +	/* Initialise and enable BCH. */
> >>  +	writel(0x1f, bch->base + BCH_BHCCR);
> >>  +	writel(BCH_BHCR_BCHE, bch->base + BCH_BHCSR);
> >>  +
> >>  +	if (params->strength == 8)
> >>  +		writel(BCH_BHCR_BSEL_MASK, bch->base + BCH_BHCSR);
> >>  +	else
> >>  +		writel(BCH_BHCR_BSEL_MASK, bch->base + BCH_BHCCR);  
> > 
> > Here you write to BCH_BHCSR or BCH_BHCCR depending on
> > params->strength...
> >   
> >>  +
> >>  +	if (encode)
> >>  +		writel(BCH_BHCR_ENCE, bch->base + BCH_BHCSR);
> >>  +	else
> >>  +		writel(BCH_BHCR_ENCE, bch->base + BCH_BHCCR);  
> > 
> > ...and here depending on encode.
> > 
> > Can you explain a bit?  
> 
> BCH_BHCSR / BCH_BHCCR are set and clear registers for the BCH_BHCR
> register, which is itself read-only. The BSEL field is used to toggle
> between a strength of 4 (if cleared) and 8 (if set), while the ENCE
> field configures the IP for 'encoding' mode.

All clear. Can you add a short comment to explain it somewhere?


Thanks,
Miquèl

______________________________________________________
Linux MTD discussion mailing list
http://lists.infradead.org/mailman/listinfo/linux-mtd/