Re: [PATCH v2 10/10] spi: atmel-quadspi: add support for sam9x60 qspi controller

[<Tudor.Ambarus@xxxxxxxxxxxxx>]

On 02/01/2019 09:07 AM, Tudor.Ambarus@xxxxxxxxxxxxx wrote:

cut

>>> diff --git a/drivers/spi/atmel-quadspi.c b/drivers/spi/atmel-quadspi.c

cut

>>> +static int atmel_sam9x60_qspi_set_cfg(void __iomem *base,
>>> +				      const struct spi_mem_op *op,
>>> +				      struct atmel_qspi_cfg *cfg)
>>> +{
>>> +	int ret = atmel_qspi_set_mode(cfg, op);
>>> +
>>> +	if (ret)
>>> +		return ret;
>>> +
>>> +	ret = atmel_qspi_set_address_mode(cfg, op);
>>> +	if (ret)
>>> +		return ret;
>>> +
>>> +	cfg->ifr |= QSPI_IFR_INSTEN;
>>> +	cfg->icr |= QSPI_ICR_INST(op->cmd.opcode);
>>> +
>>> +	/* Set data enable */
>>> +	if (op->data.nbytes)
>>> +		cfg->ifr |= QSPI_IFR_DATAEN;
>>> +
>>> +	if (!op->addr.nbytes) {
>>> +		cfg->ifr |= QSPI_IFR_TFRTYP_TRSFR_REG;
>>> +		if (op->data.dir == SPI_MEM_DATA_OUT)
>>> +			cfg->ifr |= QSPI_IFR_APBTFRTYP_WRITE;
>>> +		else
>>> +			cfg->ifr |= QSPI_IFR_APBTFRTYP_READ;
>>> +	} else {
>>> +		cfg->ifr |= QSPI_IFR_TFRTYP_TRSFR_MEM;
>>
>> Can you try doing only regular transfers and let me know if it still
>> works. Support for mem transfers can then be added along with dirmap
>> support.
> 
> should work. Will try and let you know.

you were right, it works. I will let mem transfer logic for dirmap support.

Cheers,
ta

______________________________________________________
Linux MTD discussion mailing list
http://lists.infradead.org/mailman/listinfo/linux-mtd/