Commit f9ebd1bb4103 ("mtd: rawnand: Deprecate ->erase()") discouraged the use of this hook, so I am happy to follow the suggestion. Although the Denali IP provides a special MAP10 command for erasing, using it would not buy us much. The Denali IP actually works with the generic erasing by single_erase() + ->cmdfunc hook (nand_command_lp) + ->cmd_ctrl hook (denali_cmd_ctrl). This method is also deprecated, but denali_erase() can go away irrespective of ->exec_op conversion. Signed-off-by: Masahiro Yamada <yamada.masahiro@xxxxxxxxxxxxx> --- drivers/mtd/nand/raw/denali.c | 21 --------------------- 1 file changed, 21 deletions(-) diff --git a/drivers/mtd/nand/raw/denali.c b/drivers/mtd/nand/raw/denali.c index 6e8edc9..21320b1 100644 --- a/drivers/mtd/nand/raw/denali.c +++ b/drivers/mtd/nand/raw/denali.c @@ -37,9 +37,6 @@ #define DENALI_MAP11_ADDR ((DENALI_MAP11) | 1) /* address cycle */ #define DENALI_MAP11_DATA ((DENALI_MAP11) | 2) /* data cycle */ -/* MAP10 commands */ -#define DENALI_ERASE 0x01 - #define DENALI_BANK(denali) ((denali)->active_bank << 24) #define DENALI_INVALID_BANK -1 @@ -903,23 +900,6 @@ static int denali_waitfunc(struct nand_chip *chip) return irq_status & INTR__INT_ACT ? 0 : NAND_STATUS_FAIL; } -static int denali_erase(struct nand_chip *chip, int page) -{ - struct denali_nand_info *denali = mtd_to_denali(nand_to_mtd(chip)); - uint32_t irq_status; - - denali_reset_irq(denali); - - denali->host_write(denali, DENALI_MAP10 | DENALI_BANK(denali) | page, - DENALI_ERASE); - - /* wait for erase to complete or failure to occur */ - irq_status = denali_wait_for_irq(denali, - INTR__ERASE_COMP | INTR__ERASE_FAIL); - - return irq_status & INTR__ERASE_COMP ? 0 : -EIO; -} - static int denali_setup_data_interface(struct nand_chip *chip, int chipnr, const struct nand_data_interface *conf) { @@ -1244,7 +1224,6 @@ static int denali_attach_chip(struct nand_chip *chip) chip->ecc.write_page_raw = denali_write_page_raw; chip->ecc.read_oob = denali_read_oob; chip->ecc.write_oob = denali_write_oob; - chip->legacy.erase = denali_erase; ret = denali_multidev_fixup(denali); if (ret) -- 2.7.4 ______________________________________________________ Linux MTD discussion mailing list http://lists.infradead.org/mailman/listinfo/linux-mtd/