Re: [PATCH 2/8] dt-bindings: mtd: ingenic: Add compatible strings for the JZ4725B

[Boris Brezillon <bbrezillon@xxxxxxxxxx>]

On Thu, 17 Jan 2019 22:06:28 -0300
Paul Cercueil <paul@xxxxxxxxxxxxxxx> wrote:

> Add compatible strings to probe the jz4780-nand and jz4780-bch drivers
> from devicetree on the JZ4725B SoC from Ingenic.
> 
> Signed-off-by: Paul Cercueil <paul@xxxxxxxxxxxxxxx>

Reviewed-by: Boris Brezillon <bbrezillon@xxxxxxxxxx>

> ---
>  Documentation/devicetree/bindings/mtd/ingenic,jz4780-nand.txt | 8 ++++++--
>  1 file changed, 6 insertions(+), 2 deletions(-)
> 
> diff --git a/Documentation/devicetree/bindings/mtd/ingenic,jz4780-nand.txt b/Documentation/devicetree/bindings/mtd/ingenic,jz4780-nand.txt
> index 29ea5853ca91..8ebed442ac55 100644
> --- a/Documentation/devicetree/bindings/mtd/ingenic,jz4780-nand.txt
> +++ b/Documentation/devicetree/bindings/mtd/ingenic,jz4780-nand.txt
> @@ -6,7 +6,9 @@ memory-controllers/ingenic,jz4780-nemc.txt), and thus NAND device nodes must
>  be children of the NEMC node.
>  
>  Required NAND controller device properties:
> -- compatible: Should be set to "ingenic,jz4780-nand".
> +- compatible: Should be one of:
> +  * ingenic,jz4725b-nand
> +  * ingenic,jz4780-nand
>  - reg: For each bank with a NAND chip attached, should specify a bank number,
>    an offset of 0 and a size of 0x1000000 (i.e. the whole NEMC bank).
>  
> @@ -72,7 +74,9 @@ NAND devices. The following is a description of the device properties for a
>  BCH controller.
>  
>  Required BCH properties:
> -- compatible: Should be set to "ingenic,jz4780-bch".
> +- compatible: Should be one of:
> +  * ingenic,jz4725b-bch
> +  * ingenic,jz4780-bch
>  - reg: Should specify the BCH controller registers location and length.
>  - clocks: Clock for the BCH controller.
>  


______________________________________________________
Linux MTD discussion mailing list
http://lists.infradead.org/mailman/listinfo/linux-mtd/