Re: [PATCH v4 0/3] mtd: rawnand: add STM32 FMC2 NAND flash controller driver

[Miquel Raynal <miquel.raynal@xxxxxxxxxxx>]

Hi Christophe,

Christophe Kerello <christophe.kerello@xxxxxx> wrote on Fri, 14 Dec
2018 10:58:05 +0100:

> This patchset adds the support for the STMicroelectronics FMC2 NAND flash
> controller found on STM32MP SOCs.
> 
> This patchset supports:
>   - the command sequencer feature, a hardware accelerator for read/write
>     within a page
>   - the manual mode feature, useful for debug purpose
>   - a maximum 8k page size
>   - following ECC strength and step size
> 	- nand-ecc-strength = <8>, nand-ecc-step-size = <512> (BCH8)
> 	- nand-ecc-strength = <4>, nand-ecc-step-size = <512> (BCH4)
> 	- nand-ecc-strength = <1>, nand-ecc-step-size = <512> (Extended
> 	  ecc based on HAMMING)
>     
> This patchset has been tested on Micron MT29F8G08ABACAH4 (8-bit SLC NAND)
> and MT29F8G16ABACAH4 (16-bit SLC NAND)

Series applied on nand/next.


Thanks,
Miquèl

______________________________________________________
Linux MTD discussion mailing list
http://lists.infradead.org/mailman/listinfo/linux-mtd/