Re: [PATCH v4 1/7] spi: add support for octo mode I/O data transfer

[Boris Brezillon <boris.brezillon@xxxxxxxxxxx>]

Hi Yogesh,

On Thu, 22 Nov 2018 05:14:31 +0000
Yogesh Narayan Gaur <yogeshnarayan.gaur@xxxxxxx> wrote:

> Add flags for Octo mode I/O data transfer
> Required for the SPI controller which can do the data transfer (TX/RX)
> on 8 data lines e.g. NXP FlexSPI controller.
>  SPI_TX_OCTO: transmit with 8 wires
>  SPI_RX_OCTO: receive with 8 wires
> 
> Signed-off-by: Yogesh Gaur <yogeshnarayan.gaur@xxxxxxx>
> Reviewed-by: Boris Brezillon <boris.brezillon@xxxxxxxxxxx>
> ---
> Changes for v4:
> - Rebase on top of v4.20-rc2
> Changes for v3:
> - Modified string 'octal' with 'octo'.

When I listed the differences between your version and mine, I
mentioned the OCTO vs OCTAL name, but I didn't say my decision was the
correct one :-). Looks like OCTAL is the term employed almost
everywhere, and it's also consistent with DUAL. Would you mind
sending a new version reverting the name to OCTAL.

Sorry for the unclear statement in my previous review.

Regards,

Boris

______________________________________________________
Linux MTD discussion mailing list
http://lists.infradead.org/mailman/listinfo/linux-mtd/