Re: [PATCH] mtd: spi-nor: Return error when nor->addr_width not match the device size

[Boris Brezillon <boris.brezillon@xxxxxxxxxxx>]

On Wed, 14 Nov 2018 20:56:05 +0800
Liu Xiang <liu.xiang6@xxxxxxxxxx> wrote:

> In is25lp256, the DWORD1 of JEDEC Basic Flash Parameter Header
> is 0xfff920e5. So the DWORD1[18:17] Address Bytes bits are 0b00,
> means that 3-Byte only addressing.

According to your other patch this NOR supports 4B opcode, which means
the SFDP table is wrong.

> But the device size is larger
> than 16MB, nor->addr_width must be 4 to access the whole address.
> An error should be returned when nor->addr_width not match

						   ^does not

> the device size in spi_nor_parse_sfdp().
> 
> Suggested-by: Boris Brezillon <boris.brezillon@xxxxxxxxxxx>
> Signed-off-by: Liu Xiang <liu.xiang6@xxxxxxxxxx>
> ---
>  drivers/mtd/spi-nor/spi-nor.c | 4 ++++
>  1 file changed, 4 insertions(+)
> 
> diff --git a/drivers/mtd/spi-nor/spi-nor.c b/drivers/mtd/spi-nor/spi-nor.c
> index 3eba13a..77eaf22 100644
> --- a/drivers/mtd/spi-nor/spi-nor.c
> +++ b/drivers/mtd/spi-nor/spi-nor.c
> @@ -2669,6 +2669,10 @@ static int spi_nor_parse_bfpt(struct spi_nor *nor,
>  	}
>  	params->size >>= 3; /* Convert to bytes. */
>  
> +	/*if the device exceeds 16MiB, addr_width must be 4*/

Please add a white space after '/*' and before '*/':

	/* If the device exceeds 16MiB, ->addr_width must be 4. */

> +	if ((params->size > 0x1000000) && (nor->addr_width == 3))

Parens are not needed around sub-conditions:

	if (params->size > 0x1000000 && nor->addr_width == 3)

> +		return -EINVAL;
> +

I'm not sure this is correct. Looks like some NORs only support 3B
opcodes but have a "4-byte addressing" mode (see set_4byte() [1]).
Don't know what's reported by the BFPT section in this case though
(BFPT_DWORD1_ADDRESS_BYTES_3_ONLY or BFPT_DWORD1_ADDRESS_BYTES_3_OR_4).

Anyway, I think this check should be moved here [2] to cover the
non-SFDP case.

>  	/* Fast Read settings. */
>  	for (i = 0; i < ARRAY_SIZE(sfdp_bfpt_reads); i++) {
>  		const struct sfdp_bfpt_read *rd = &sfdp_bfpt_reads[i];

[1]https://elixir.bootlin.com/linux/v4.20-rc2/source/drivers/mtd/spi-nor/spi-nor.c#L278
[2]https://elixir.bootlin.com/linux/v4.20-rc2/source/drivers/mtd/spi-nor/spi-nor.c#L3758

______________________________________________________
Linux MTD discussion mailing list
http://lists.infradead.org/mailman/listinfo/linux-mtd/