Re: [PATCH 3/7] mtd: spi-nor: add restriction for nmaps in smpt parser

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Thu, 8 Nov 2018 11:07:11 +0000
<Tudor.Ambarus@xxxxxxxxxxxxx> wrote:

> The map selector is limited to a maximum of 8 bits, allowing
> for a maximum of 256 possible map configurations. The total
> number of map configurations should be addressable by the
> total number of bits described by the detection commands.
> 
> For example: if there are five to eight possible sector map
> configurations, at least three configuration detection commands
> will be needed to extract three bits of configuration selection
> information from the device in order to identify which configuration
> is currently in use.
> 
> Suggested-by: Boris Brezillon <boris.brezillon@xxxxxxxxxxx>

I don't remember suggesting this :-).

> Signed-off-by: Tudor Ambarus <tudor.ambarus@xxxxxxxxxxxxx>
> ---
>  drivers/mtd/spi-nor/spi-nor.c | 15 +++++++++++++--
>  1 file changed, 13 insertions(+), 2 deletions(-)
> 
> diff --git a/drivers/mtd/spi-nor/spi-nor.c b/drivers/mtd/spi-nor/spi-nor.c
> index 59dcedb08691..bd1866d714f2 100644
> --- a/drivers/mtd/spi-nor/spi-nor.c
> +++ b/drivers/mtd/spi-nor/spi-nor.c
> @@ -2868,7 +2868,7 @@ static const u32 *spi_nor_get_map_in_use(struct spi_nor *nor, const u32 *smpt,
>  	const u32 *ret = NULL;
>  	u32 addr;
>  	int err;
> -	u8 i;
> +	u8 i, ncmds, nmaps;
>  	u8 addr_width, read_opcode, read_dummy;
>  	u8 read_data_mask, data_byte, map_id;
>  
> @@ -2877,6 +2877,7 @@ static const u32 *spi_nor_get_map_in_use(struct spi_nor *nor, const u32 *smpt,
>  	read_opcode = nor->read_opcode;
>  
>  	map_id = 0;
> +	ncmds = 0;
>  	/* Determine if there are any optional Detection Command Descriptors */
>  	for (i = 0; i < smpt_len; i += 2) {
>  		if (smpt[i] & SMPT_DESC_TYPE_MAP)
> @@ -2896,6 +2897,7 @@ static const u32 *spi_nor_get_map_in_use(struct spi_nor *nor, const u32 *smpt,
>  		 * Configuration that is currently in use.
>  		 */
>  		map_id = map_id << 1 | !!(data_byte & read_data_mask);
> +		ncmds++;
>  	}
>  
>  	/*
> @@ -2905,7 +2907,16 @@ static const u32 *spi_nor_get_map_in_use(struct spi_nor *nor, const u32 *smpt,
>  	 *
>  	 * Find the matching configuration map.
>  	 */
> -	while (i < smpt_len) {
> +	for (nmaps = 0; i < smpt_len; nmaps++) {
> +		/*
> +		 * The map selector is limited to a maximum of 8 bits, allowing
> +		 * for a maximum of 256 possible map configurations. The total
> +		 * number of map configurations should be addressable by the
> +		 * total number of bits described by the detection commands.
> +		 */
> +		if (ncmds && nmaps >= (1 << (ncmds + 1)))
> +			break;
> +

Maybe I missed something but it sounds like this change is just
optimizing the SPMT parsing a bit, and to be honest, I'm not sure this
is really needed. Most of the time, smpt_len will be rather small, so
trying to bail out earlier is not bringing much perf improvements.

>  		if (SMPT_MAP_ID(smpt[i]) == map_id) {
>  			ret = smpt + i;
>  			break;


______________________________________________________
Linux MTD discussion mailing list
http://lists.infradead.org/mailman/listinfo/linux-mtd/



[Index of Archives]     [LARTC]     [Bugtraq]     [Yosemite Forum]     [Photo]

  Powered by Linux