Re: Query Regarding NOR flash page size calculation s25fl512s

[Boris Brezillon <boris.brezillon@xxxxxxxxxxx>]

Hi Yogesh,

On Mon, 17 Sep 2018 10:05:27 +0000
Yogesh Narayan Gaur <yogeshnarayan.gaur@xxxxxxx> wrote:

> Hi All,
> 
> Please suggest how can we work for this flash, s25fl512s?
> Passing flag SPI_NOR_SKIP_SFDP would going to break functionality of 1-2-2/1-4-4 protocol mode, as only through SFDP parameter read we get information for the dummy cycles, mode bits etc for this flash.
> 
> But, page_size value is getting populated wrongly for case when value of CR3V[4] is 0 for this flash.
> 
> --
> Regards
> Yogesh Gaur
> 
> > -----Original Message-----
> > From: linux-mtd [mailto:linux-mtd-bounces@xxxxxxxxxxxxxxxxxxx] On Behalf Of
> > Yogesh Gaur
> > Sent: Friday, August 31, 2018 10:28 AM
> > To: linux-mtd@xxxxxxxxxxxxxxxxxxx
> > Subject: Query Regarding NOR flash page size calculation s25fl512s
> > 
> > Hi All,
> > 
> > I have query and concern regarding page_size calculation for the underlying
> > NOR flashes.
> > 
> > I have spansion, ‘s25fl512s’ flash connected on my target.
> > 
> > With SFDP param reading, page_size for this flash is assigned as 0x200 using
> > below routine.
> >    /* Page size: this field specifies 'N' so the page size = 2^N bytes. */
> >    params->page_size = bfpt.dwords[BFPT_DWORD(11)];
> >    params->page_size &= BFPT_DWORD11_PAGE_SIZE_MASK;
> >    params->page_size >>= BFPT_DWORD11_PAGE_SIZE_SHIFT;
> >    params->page_size = 1U << params->page_size;
> > 
> > As per the BG of S25FS512S_512_M flash and SFDP header info table above
> > calculation are correct.
> > 
> > But final value of the page_size for this flash is depends on the configuration
> > register CR3V[4], page buffer wrap, it can be either of
> > 256 byte (0) or 512 byte (1).
> > 
> > For my case, this value is 0 and page_size becomes 0x100 bytes but with SFDP
> > header read, value for this is being assigned as 0x200.
> > Due to this, I am getting data corruption.
> > 
> > Please suggest, how can we check and proceed in these case. I guess this is
> > specific to spansion family of flashes.

I guess we need some kind of ->fixup() hook that the core would call
after SFDP has been parsed, so that vendors can adjust SPI NOR params.

Marek, Cyrille, any opinion on that?

Thanks,

Boris

______________________________________________________
Linux MTD discussion mailing list
http://lists.infradead.org/mailman/listinfo/linux-mtd/