On Sat, 14 Jul 2018 18:32:51 +0200 Miquel Raynal <miquel.raynal at bootlin.com> wrote: > A report from Colin Ian King pointed a CoverityScan issue where error > values on these helpers where not checked in the drivers. These > helpers could error out only in case of a software bug in driver code, > not because of a runtime/hardware error but in any cases it is safer > to handle these errors properly. > > Fix the Tegra NAND controller driver implementation by checking > potential negative error values coming from these helpers. Hm, ok. I thought you were opting for a return 0 + WARN_ON() approach, what made you change your mind? > > Signed-off-by: Miquel Raynal <miquel.raynal at bootlin.com> > --- > > This patch should have been part of the following series: > http://lists.infradead.org/pipermail/linux-mtd/2018-July/082654.html > It will be squashed with original commit introducing this driver. > > Thanks, > Miqu?l > > drivers/mtd/nand/raw/tegra_nand.c | 7 +++++++ > 1 file changed, 7 insertions(+) > > diff --git a/drivers/mtd/nand/raw/tegra_nand.c b/drivers/mtd/nand/raw/tegra_nand.c > index 22d6a7f9ff80..59ead8f41718 100644 > --- a/drivers/mtd/nand/raw/tegra_nand.c > +++ b/drivers/mtd/nand/raw/tegra_nand.c > @@ -379,6 +379,9 @@ static int tegra_nand_cmd(struct nand_chip *chip, > case NAND_OP_ADDR_INSTR: > offset = nand_subop_get_addr_start_off(subop, op_id); > naddrs = nand_subop_get_num_addr_cyc(subop, op_id); > + if (offset < 0 || naddrs < 0) > + return -EINVAL; > + > addrs = &instr->ctx.addr.addrs[offset]; > > cmd |= COMMAND_ALE | COMMAND_ALE_SIZE(naddrs); > @@ -395,6 +398,8 @@ static int tegra_nand_cmd(struct nand_chip *chip, > case NAND_OP_DATA_IN_INSTR: > size = nand_subop_get_data_len(subop, op_id); > offset = nand_subop_get_data_start_off(subop, op_id); > + if (size < 0 || offset < 0) > + return -EINVAL; > > cmd |= COMMAND_TRANS_SIZE(size) | COMMAND_PIO | > COMMAND_RX | COMMAND_A_VALID; > @@ -405,6 +410,8 @@ static int tegra_nand_cmd(struct nand_chip *chip, > case NAND_OP_DATA_OUT_INSTR: > size = nand_subop_get_data_len(subop, op_id); > offset = nand_subop_get_data_start_off(subop, op_id); > + if (size < 0 || offset < 0) > + return -EINVAL; > > cmd |= COMMAND_TRANS_SIZE(size) | COMMAND_PIO | > COMMAND_TX | COMMAND_A_VALID;