Hi Victor, On Wed, Sep 20, 2023 at 4:54 PM Victor Shih <victorshihgli@xxxxxxxxx> wrote: > > On Tue, Sep 19, 2023 at 3:31 PM Kai-Heng Feng > <kai.heng.feng@xxxxxxxxxxxxx> wrote: > > > > Hi Victor, > > > > On Tue, Sep 19, 2023 at 3:10 PM Victor Shih <victorshihgli@xxxxxxxxx> wrote: > > > > > > On Tue, Sep 19, 2023 at 12:24 PM Kai-Heng Feng > > > <kai.heng.feng@xxxxxxxxxxxxx> wrote: > > > > > > > > Hi Victor, > > > > > > > > On Mon, Sep 18, 2023 at 6:31 PM Victor Shih <victorshihgli@xxxxxxxxx> wrote: > > > > > > > > > > From: Victor Shih <victor.shih@xxxxxxxxxxxxxxxxxxx> > > > > > > > > > > Due to a flaw in the hardware design, the GL975x replay timer frequently > > > > > times out when ASPM is enabled. As a result, the system will resume > > > > > immediately when it enters suspend. Therefore, the replay timer > > > > > timeout must be masked. > > > > > > > > This patch solves AER error when its PCI config gets accessed, but the > > > > AER still happens at system suspend: > > > > > > > > [ 1100.103603] ACPI: EC: interrupt blocked > > > > [ 1100.268244] ACPI: EC: interrupt unblocked > > > > [ 1100.326960] pcieport 0000:00:1c.0: AER: Corrected error received: > > > > 0000:00:1c.0 > > > > [ 1100.326991] pcieport 0000:00:1c.0: PCIe Bus Error: > > > > severity=Corrected, type=Data Link Layer, (Transmitter ID) > > > > [ 1100.326993] pcieport 0000:00:1c.0: device [8086:7ab9] error > > > > status/mask=00001000/00002000 > > > > [ 1100.326996] pcieport 0000:00:1c.0: [12] Timeout > > > > > > > > Kai-Heng > > > > > > > > > > Hi, Kai-Heng > > > > > > Could you try applying the patch and re-testing again after restarting > > > the system? > > > > Same issue happens after coldboot. > > > > > Because I applied the patch and restarted the system and it didn't happen. > > > The system can enter suspend normally. > > > > > > If you still have the issue after following the above instructions, > > > please provide me with your environment and I will verify it again. > > > > The patch gets applied on top of next-20230918. Please let me know > > what else you want to know. > > > > Kai-Heng > > > > Hi, Kai-Heng > > If I want to mask the replay timer timeout AER of the upper layer root port, > could you give me some suggestions? > Or could you provide sample code for my reference? I am not aware of anyway to mask "replay timer timeout" from root port. I wonder if the device supoprt D3hot? Or should it stay at D0 when ASPM L1.2 is enabled? Kai-Heng > > Thanks, Victor Shih > > > > > > > Thanks, Victor Shih > > > > > > > > > > > > > Signed-off-by: Victor Shih <victor.shih@xxxxxxxxxxxxxxxxxxx> > > > > > --- > > > > > drivers/mmc/host/sdhci-pci-gli.c | 16 ++++++++++++++++ > > > > > 1 file changed, 16 insertions(+) > > > > > > > > > > diff --git a/drivers/mmc/host/sdhci-pci-gli.c b/drivers/mmc/host/sdhci-pci-gli.c > > > > > index d83261e857a5..d8a991b349a8 100644 > > > > > --- a/drivers/mmc/host/sdhci-pci-gli.c > > > > > +++ b/drivers/mmc/host/sdhci-pci-gli.c > > > > > @@ -28,6 +28,9 @@ > > > > > #define PCI_GLI_9750_PM_CTRL 0xFC > > > > > #define PCI_GLI_9750_PM_STATE GENMASK(1, 0) > > > > > > > > > > +#define PCI_GLI_9750_CORRERR_MASK 0x214 > > > > > +#define PCI_GLI_9750_CORRERR_MASK_REPLAY_TIMER_TIMEOUT BIT(12) > > > > > + > > > > > #define SDHCI_GLI_9750_CFG2 0x848 > > > > > #define SDHCI_GLI_9750_CFG2_L1DLY GENMASK(28, 24) > > > > > #define GLI_9750_CFG2_L1DLY_VALUE 0x1F > > > > > @@ -152,6 +155,9 @@ > > > > > #define PCI_GLI_9755_PM_CTRL 0xFC > > > > > #define PCI_GLI_9755_PM_STATE GENMASK(1, 0) > > > > > > > > > > +#define PCI_GLI_9755_CORRERR_MASK 0x214 > > > > > +#define PCI_GLI_9755_CORRERR_MASK_REPLAY_TIMER_TIMEOUT BIT(12) > > > > > + > > > > > #define SDHCI_GLI_9767_GM_BURST_SIZE 0x510 > > > > > #define SDHCI_GLI_9767_GM_BURST_SIZE_AXI_ALWAYS_SET BIT(8) > > > > > > > > > > @@ -561,6 +567,11 @@ static void gl9750_hw_setting(struct sdhci_host *host) > > > > > value &= ~PCI_GLI_9750_PM_STATE; > > > > > pci_write_config_dword(pdev, PCI_GLI_9750_PM_CTRL, value); > > > > > > > > > > + /* mask the replay timer timeout of AER */ > > > > > + pci_read_config_dword(pdev, PCI_GLI_9750_CORRERR_MASK, &value); > > > > > + value |= PCI_GLI_9750_CORRERR_MASK_REPLAY_TIMER_TIMEOUT; > > > > > + pci_write_config_dword(pdev, PCI_GLI_9750_CORRERR_MASK, value); > > > > > + > > > > > gl9750_wt_off(host); > > > > > } > > > > > > > > > > @@ -770,6 +781,11 @@ static void gl9755_hw_setting(struct sdhci_pci_slot *slot) > > > > > value &= ~PCI_GLI_9755_PM_STATE; > > > > > pci_write_config_dword(pdev, PCI_GLI_9755_PM_CTRL, value); > > > > > > > > > > + /* mask the replay timer timeout of AER */ > > > > > + pci_read_config_dword(pdev, PCI_GLI_9755_CORRERR_MASK, &value); > > > > > + value |= PCI_GLI_9755_CORRERR_MASK_REPLAY_TIMER_TIMEOUT; > > > > > + pci_write_config_dword(pdev, PCI_GLI_9755_CORRERR_MASK, value); > > > > > + > > > > > gl9755_wt_off(pdev); > > > > > } > > > > > > > > > > -- > > > > > 2.25.1 > > > > >
