Hi Yann/Christophe,
thanks for your patch!
On Fri, Sep 1, 2023 at 2:08 PM Yann Gautier <yann.gautier@xxxxxxxxxxx> wrote:
> From: Christophe Kerello <christophe.kerello@xxxxxxxxxxx>
>
> Add the support of SDIO in-band interrupt mode for STM32 variant.
> It allows the SD I/O card to interrupt the host on SDMMC_D1 data line.
>
> Signed-off-by: Christophe Kerello <christophe.kerello@xxxxxxxxxxx>
> Signed-off-by: Yann Gautier <yann.gautier@xxxxxxxxxxx>
(...)
> +++ b/drivers/mmc/host/mmci.h
> @@ -332,6 +332,7 @@ enum mmci_busy_state {
> * @opendrain: bitmask identifying the OPENDRAIN bit inside MMCIPOWER register
> * @dma_lli: true if variant has dma link list feature.
> * @stm32_idmabsize_mask: stm32 sdmmc idma buffer size.
> + * @use_sdio_irq: allow SD I/O card to interrupt the host
The documentation tag should be one line up (compare to the members...)
> @@ -376,6 +377,7 @@ struct variant_data {
> u32 start_err;
> u32 opendrain;
> u8 dma_lli:1;
> + u8 use_sdio_irq:1;
1. bool use_sdio_irq;
2. supports_sdio_irq is more to the point don't you think?
Especially since it activates these two callbacks:
> + void (*enable_sdio_irq)(struct mmci_host *host, int enable);
> + void (*sdio_irq)(struct mmci_host *host, u32 status);
Further: all the Ux500 variants support this (bit 22) as well, so enable those
too in their vendor data. All I have is out-of-band signaling with an GPIO IRQ
on my Broadcom chips but I think it works (maybe Ulf has tested it in the
far past).
Yours,
Linus Walleij
