Hi, Adrian
On Wed, Apr 12, 2023 at 9:13 PM Adrian Hunter <adrian.hunter@xxxxxxxxx> wrote:
>
> On 31/03/23 13:55, Victor Shih wrote:
> > Sdhci_uhs2_do_detect_init() is a sdhci version of mmc's uhs2_detect_init
> > operation. After detected, the host's UHS-II capabilities will be set up
> > here and interrupts will also be enabled.
> >
> > Signed-off-by: Ben Chuang <ben.chuang@xxxxxxxxxxxxxxxxxxx>
> > Signed-off-by: AKASHI Takahiro <takahiro.akashi@xxxxxxxxxx>
> > Signed-off-by: Victor Shih <victor.shih@xxxxxxxxxxxxxxxxxxx>
> > ---
> > drivers/mmc/host/sdhci-uhs2.c | 117 ++++++++++++++++++++++++++++++++++
> > 1 file changed, 117 insertions(+)
> >
> > diff --git a/drivers/mmc/host/sdhci-uhs2.c b/drivers/mmc/host/sdhci-uhs2.c
> > index 9b519bd6d76e..e2972be1889f 100644
> > --- a/drivers/mmc/host/sdhci-uhs2.c
> > +++ b/drivers/mmc/host/sdhci-uhs2.c
> > @@ -334,6 +334,123 @@ static int sdhci_uhs2_set_ios(struct mmc_host *mmc, struct mmc_ios *ios)
> > * *
> > \*****************************************************************************/
> >
> > +static int sdhci_uhs2_interface_detect(struct sdhci_host *host)
> > +{
> > + /* 100ms */
> > + int timeout = 100000;
> > + u32 val;
> > +
> > + udelay(200); /* wait for 200us before check */
>
> There does not seem to be any need for this function
> to be atomic, so this should use usleep_range() not udelay().
>
I will update it to the V8 version.
> > +
> > + if (read_poll_timeout_atomic(sdhci_readl, val, (val & SDHCI_UHS2_IF_DETECT),
> > + 100, timeout, true, host, SDHCI_PRESENT_STATE)) {
>
> Does not need to be atomic
>
I will update it to the V8 version.
> > + pr_warn("%s: not detect UHS2 interface in 200us.\n", mmc_hostname(host->mmc));
> > + sdhci_dumpregs(host);
> > + return -EIO;
> > + }
> > +
> > + /* Enable UHS2 error interrupts */
> > + sdhci_uhs2_clear_set_irqs(host, SDHCI_INT_ALL_MASK, SDHCI_UHS2_INT_ERROR_MASK);
> > +
> > + /* 150ms */
> > + timeout = 150000;
> > + if (read_poll_timeout_atomic(sdhci_readl, val, (val & SDHCI_UHS2_LANE_SYNC),
>
> Does not need to be atomic
>
I will update it to the V8 version.
> > + 100, timeout, true, host, SDHCI_PRESENT_STATE)) {
> > + pr_warn("%s: UHS2 Lane sync fail in 150ms.\n", mmc_hostname(host->mmc));
> > + sdhci_dumpregs(host);
> > + return -EIO;
> > + }
> > +
> > + DBG("%s: UHS2 Lane synchronized in UHS2 mode, PHY is initialized.\n",
> > + mmc_hostname(host->mmc));
> > + return 0;
> > +}
> > +
> > +static int sdhci_uhs2_init(struct sdhci_host *host)
> > +{
> > + u16 caps_ptr = 0;
> > + u32 caps_gen = 0;
> > + u32 caps_phy = 0;
> > + u32 caps_tran[2] = {0, 0};
> > + struct mmc_host *mmc = host->mmc;
> > +
> > + caps_ptr = sdhci_readw(host, SDHCI_UHS2_CAPS_PTR);
> > + if (caps_ptr < 0x100 || caps_ptr > 0x1FF) {
> > + pr_err("%s: SDHCI_UHS2_CAPS_PTR(%d) is wrong.\n",
> > + mmc_hostname(mmc), caps_ptr);
> > + return -ENODEV;
> > + }
> > + caps_gen = sdhci_readl(host, caps_ptr + SDHCI_UHS2_CAPS_OFFSET);
> > + caps_phy = sdhci_readl(host, caps_ptr + SDHCI_UHS2_CAPS_PHY_OFFSET);
> > + caps_tran[0] = sdhci_readl(host, caps_ptr + SDHCI_UHS2_CAPS_TRAN_OFFSET);
> > + caps_tran[1] = sdhci_readl(host, caps_ptr + SDHCI_UHS2_CAPS_TRAN_1_OFFSET);
> > +
> > + /* General Caps */
> > + mmc->uhs2_caps.dap = caps_gen & SDHCI_UHS2_CAPS_DAP_MASK;
> > + mmc->uhs2_caps.gap = FIELD_GET(SDHCI_UHS2_CAPS_GAP_MASK, caps_gen);
> > + mmc->uhs2_caps.n_lanes = FIELD_GET(SDHCI_UHS2_CAPS_LANE_MASK, caps_gen);
> > + mmc->uhs2_caps.addr64 = (caps_gen & SDHCI_UHS2_CAPS_ADDR_64) ? 1 : 0;
> > + mmc->uhs2_caps.card_type = FIELD_GET(SDHCI_UHS2_CAPS_DEV_TYPE_MASK, caps_gen);
> > +
> > + /* PHY Caps */
> > + mmc->uhs2_caps.phy_rev = caps_phy & SDHCI_UHS2_CAPS_PHY_REV_MASK;
> > + mmc->uhs2_caps.speed_range = FIELD_GET(SDHCI_UHS2_CAPS_PHY_RANGE_MASK, caps_phy);
> > + mmc->uhs2_caps.n_lss_sync = FIELD_GET(SDHCI_UHS2_CAPS_PHY_N_LSS_SYN_MASK, caps_phy);
> > + mmc->uhs2_caps.n_lss_dir = FIELD_GET(SDHCI_UHS2_CAPS_PHY_N_LSS_DIR_MASK, caps_phy);
> > + if (mmc->uhs2_caps.n_lss_sync == 0)
> > + mmc->uhs2_caps.n_lss_sync = 16 << 2;
> > + else
> > + mmc->uhs2_caps.n_lss_sync <<= 2;
> > + if (mmc->uhs2_caps.n_lss_dir == 0)
> > + mmc->uhs2_caps.n_lss_dir = 16 << 3;
> > + else
> > + mmc->uhs2_caps.n_lss_dir <<= 3;
> > +
> > + /* LINK/TRAN Caps */
> > + mmc->uhs2_caps.link_rev = caps_tran[0] & SDHCI_UHS2_CAPS_TRAN_LINK_REV_MASK;
> > + mmc->uhs2_caps.n_fcu = FIELD_GET(SDHCI_UHS2_CAPS_TRAN_N_FCU_MASK, caps_tran[0]);
> > + if (mmc->uhs2_caps.n_fcu == 0)
> > + mmc->uhs2_caps.n_fcu = 256;
> > + mmc->uhs2_caps.host_type = FIELD_GET(SDHCI_UHS2_CAPS_TRAN_HOST_TYPE_MASK, caps_tran[0]);
> > + mmc->uhs2_caps.maxblk_len = FIELD_GET(SDHCI_UHS2_CAPS_TRAN_BLK_LEN_MASK, caps_tran[0]);
> > + mmc->uhs2_caps.n_data_gap = caps_tran[1] & SDHCI_UHS2_CAPS_TRAN_1_N_DATA_GAP_MASK;
> > +
> > + return 0;
> > +}
> > +
> > +static int sdhci_uhs2_do_detect_init(struct mmc_host *mmc)
> > +{
> > + struct sdhci_host *host = mmc_priv(mmc);
> > + int ret = -EIO;
> > +
> > + DBG("Begin do uhs2 detect init.\n");
> > +
> > + if (sdhci_uhs2_interface_detect(host)) {
> > + pr_warn("%s: cannot detect UHS2 interface.\n",
> > + mmc_hostname(host->mmc));
> > + goto out;
>
> Might as well be
>
> return -EIO;
>
I will update it to the V8 version.
> > + }
> > +
> > + if (sdhci_uhs2_init(host)) {
> > + pr_warn("%s: UHS2 init fail.\n", mmc_hostname(host->mmc));
> > + goto out;
>
> Might as well be
>
> return -EIO;
>
I will update it to the V8 version.
> > + }
> > +
> > + /* Init complete, do soft reset and enable UHS2 error irqs. */
> > + sdhci_uhs2_reset(host, SDHCI_UHS2_SW_RESET_SD);
> > + sdhci_uhs2_clear_set_irqs(host, SDHCI_INT_ALL_MASK, SDHCI_UHS2_INT_ERROR_MASK);
> > + /*
> > + * N.B SDHCI_INT_ENABLE and SDHCI_SIGNAL_ENABLE was cleared
> > + * by SDHCI_UHS2_SW_RESET_SD
> > + */
> > + sdhci_writel(host, host->ier, SDHCI_INT_ENABLE);
> > + sdhci_writel(host, host->ier, SDHCI_SIGNAL_ENABLE);
> > +
> > + ret = 0;
> > +out:
> > + return ret;
>
> Might as well be
>
> return 0;
>
> so "out:" and ret not needed.
>
I will update it to the V8 version.
> > +}
> > +
> > static int sdhci_uhs2_host_ops_init(struct sdhci_host *host)
> > {
> > host->mmc_host_ops.start_signal_voltage_switch =
>
Thanks, Victor Shih
