On 31-01-22, 17:26, Ulf Hansson wrote:
> + Vinod
>
> On Fri, 21 Jan 2022 at 21:38, Sergey Shtylyov <s.shtylyov@xxxxxx> wrote:
> >
> > The 'dma_slave_config::{src|dst}_addr_width' fields have the *enum* type
> > which isn't isomorphic with the *bool* type, however is used as a boolean
> > expression. Use the *enum* dma_slave_buswidth's value corresponding to 0
> > instead.
> >
> > Found by Linux Verification Center (linuxtesting.org) with the SVACE static
> > analysis tool.
>
> I have no strong opinion, but just wanted to make sure this is inline
> with what Vinod wants.
>
> There are not so many users checking DMA_SLAVE_BUSWIDTH_UNDEFINED,
> perhaps we should simply drop it and instead leave the checks below as
> is?
DMA_SLAVE_BUSWIDTH_UNDEFINED was defined as 0.
I think it might be overkill and should be fine to keep the check as
is..
>
> >
> > Signed-off-by: Sergey Shtylyov <s.shtylyov@xxxxxx>
>
> Kind regards
> Uffe
>
> >
> > ---
> > This patch is against the 'next' branch of Ulf Hansson's 'mmc.git' repo.
> >
> > drivers/mmc/host/renesas_sdhi_sys_dmac.c | 4 ++--
> > 1 file changed, 2 insertions(+), 2 deletions(-)
> >
> > Index: mmc/drivers/mmc/host/renesas_sdhi_sys_dmac.c
> > ===================================================================
> > --- mmc.orig/drivers/mmc/host/renesas_sdhi_sys_dmac.c
> > +++ mmc/drivers/mmc/host/renesas_sdhi_sys_dmac.c
> > @@ -370,7 +370,7 @@ static void renesas_sdhi_sys_dmac_reques
> > cfg.dst_addr = res->start +
> > (CTL_SD_DATA_PORT << host->bus_shift);
> > cfg.dst_addr_width = priv->dma_priv.dma_buswidth;
> > - if (!cfg.dst_addr_width)
> > + if (cfg.dst_addr_width == DMA_SLAVE_BUSWIDTH_UNDEFINED)
> > cfg.dst_addr_width = DMA_SLAVE_BUSWIDTH_2_BYTES;
> > cfg.src_addr = 0;
> > ret = dmaengine_slave_config(host->chan_tx, &cfg);
> > @@ -389,7 +389,7 @@ static void renesas_sdhi_sys_dmac_reques
> > cfg.direction = DMA_DEV_TO_MEM;
> > cfg.src_addr = cfg.dst_addr + host->pdata->dma_rx_offset;
> > cfg.src_addr_width = priv->dma_priv.dma_buswidth;
> > - if (!cfg.src_addr_width)
> > + if (cfg.src_addr_width == DMA_SLAVE_BUSWIDTH_UNDEFINED)
> > cfg.src_addr_width = DMA_SLAVE_BUSWIDTH_2_BYTES;
> > cfg.dst_addr = 0;
> > ret = dmaengine_slave_config(host->chan_rx, &cfg);
--
~Vinod
