From: Fred Ai <fred.ai@xxxxxxxxxxxxxx>
Remove SDR104 card, SD clock's base clock
frequency is not right when insert SD2.0/SDR50 card
Signed-off-by: Fred Ai <fred.ai@xxxxxxxxxxxxxx>
---
Change in V3:
1.Set SD clock's base clock frequency to 208MHz when card mode is SDR104/HS200.
2.Set SD clock's base clock frequency to 200MHz when card mode is SD2.0/SDR50.
---
drivers/mmc/host/sdhci-pci-o2micro.c | 5 +++++
1 file changed, 5 insertions(+)
diff --git a/drivers/mmc/host/sdhci-pci-o2micro.c b/drivers/mmc/host/sdhci-pci-o2micro.c
index f55602609f8c..4ca1e8c5b631 100644
--- a/drivers/mmc/host/sdhci-pci-o2micro.c
+++ b/drivers/mmc/host/sdhci-pci-o2micro.c
@@ -577,6 +577,11 @@ static void sdhci_pci_o2_set_clock(struct sdhci_host *host, unsigned int clock)
if ((scratch_32 & 0xFFFF0000) != 0x2c280000)
o2_pci_set_baseclk(chip, 0x2c280000);
+ } else {
+ pci_read_config_dword(chip->pdev, O2_SD_PLL_SETTING, &scratch_32);
+
+ if ((scratch_32 & 0xFFFF0000) != 0x25100000)
+ o2_pci_set_baseclk(chip, 0x25100000);
}
pci_read_config_dword(chip->pdev, O2_SD_OUTPUT_CLK_SOURCE_SWITCH, &scratch_32);
--
2.32.0
