On 18-08-21, 08:21, Dmitry Osipenko wrote: > Yes, GENPD will cache the perf state across suspend/resume and initially > cached value is out of sync with h/w. > > Nothing else. But let me clarify it all again. Thanks for your explanation. > Initially the performance state of all GENPDs is 0 for all devices. > > The clock rate is preinitialized for all devices to a some default rate > by clk driver, or by bootloader or by assigned-clocks in DT. > > When device is rpm-resumed, the resume callback of a device driver > enables the clock. > > Before clock is enabled, the voltage needs to be configured in > accordance to the clk rate. > > So now we have a GENPD with pstate=0 on a first rpm-resume, which > doesn't match the h/w configuration. Calling dev_pm_opp_sync() sets the > pstate in accordance to the h/w config. What about calling dev_pm_opp_set_rate(dev, clk_get_rate(dev)) here instead ? That will work, right ? The advantage is it works without any special routine to do so. I also wonder looking at your gr3d.c changes, you set a set-opp helper, but the driver doesn't call set_opp_rate at all. Who calls it ? And if it is all about just syncing the genpd core, then can the genpd core do something like what clk framework does? i.e. allow a new optional genpd callback, get_performance_state() (just like set_performance_state()), which can be called initially by the core to get the performance to something other than zero. opp-set-rate is there to set the performance state and enable the stuff as well. That's why it looks incorrect in your case, where the function was only required to be called once, and you are ending up calling it on each resume. Limiting that with another local variable is bad as well. > In a previous v7 I proposed to preset the rpm_pstate of GENPD (perf > level that is restored before device is rpm-resumed) from PD's > attach_dev callback, but Ulf didn't like that because it requires to use > and modify GENPD 'private' variables from a PD driver. We decided that > will be better to make device drivers to explicitly sync the perf state, > which I implemented in this v8. -- viresh
