Good Morning, I've encountered a fun issue with the dw-mmc driver while working on enabling support for the Quartz-64 Model A. The regulator-fixed driver supports enabling via a gpio, but does not have the ops to set voltage as it is fixed. The dw-mmc calls mmc_regulator_set_ocr for vmmc, which attempts to set the voltage first but fails due to the lack of the voltage ops. It then bails returning -EINVAL. This leads to the following message : dwmmc_rockchip fe2b0000.mmc: could not set regulator OCR (-22) This can be fixed by switching to regulator-gpio for the vmmc supply to the sdmmc controller, however the sdio controller vmmc is provided by a fixed regulator that is always on. Obviously the regulator-gpio isn't an option, as it has no gpio to enable. Removing the vmmc phandle from the sdio node is an option, but then it doesn't fully describe the hardware (it's also a non-standard 4.4v). I had considered changing the check in dw-mmc.c [1] to continue in the case of -EINVAL, but there are other places in the regulator framework that can also return that and it doesn't address the underlying issue. As such I'm reaching out to the experts to see what the best course of action is here. Please weigh in with what you think. Very Respectfully, Peter Geis
