On Mon, 26 Apr 2021 at 09:30, Ben Chuang <benchuanggli@xxxxxxxxx> wrote:
>
> Hi Daniel,
>
> > Inserting an SD-card on an Intel NUC10i3FNK4 (which contains a GL9755)
> > results in the message:
> >
> > mmc0: 1.8V regulator output did not become stable
> >
> > Following this message, some cards work (sometimes), but most cards fail
> > with EILSEQ. This behaviour is observed on Debian 10 running kernel
> > 4.19.188, but also with 5.8.18 and 5.11.15.
>
> Glad to receive your report. Thanks.
>
> >
> > The driver currently waits 5ms after switching on the 1.8V regulator for
> > it to become stable. Increasing this to 10ms gets rid of the warning
> > about stability, but most cards still fail. Increasing it to 20ms gets
> > some cards working (a 32GB Samsung micro SD works, a 128GB ADATA
> > doesn't). At 50ms, the ADATA works most of the time, and at 100ms both
> > cards work reliably.
>
> If it is convenient, can you provide the appearance pictures and product
> links of these two cards? We want to buy them.
>
> >
> > Signed-off-by: Daniel Beer <dlbeer@xxxxxxxxx>
> > ---
> > drivers/mmc/host/sdhci-pci-gli.c | 7 ++++++-
> > 1 file changed, 6 insertions(+), 1 deletion(-)
> >
> > diff --git a/drivers/mmc/host/sdhci-pci-gli.c b/drivers/mmc/host/sdhci-pci-gli.c
> > index 592d79082f58..061618aa247f 100644
> > --- a/drivers/mmc/host/sdhci-pci-gli.c
> > +++ b/drivers/mmc/host/sdhci-pci-gli.c
> > @@ -627,8 +627,13 @@ static void sdhci_gli_voltage_switch(struct sdhci_host *host)
> > *
> > * Wait 5ms after set 1.8V signal enable in Host Control 2 register
> > * to ensure 1.8V signal enable bit is set by GL9750/GL9755.
> > + *
> > + * ...however, the controller in the NUC10i3FNK4 (a 9755) requires
> > + * slightly longer than 5ms before the control register reports that
> > + * 1.8V is ready, and far longer still before the card will actually
> > + * work reliably.
> > */
> > - usleep_range(5000, 5500);
> > + usleep_range(100000, 110000);
>
> Looks good for me.
I consider this as an ack and will add you tag to the commit. Please
tell me if I should change.
[...]
Applied for fixes and by adding the below tags, thanks!
Acked-by: Ben Chuang <benchuanggli@xxxxxxxxx>
Fixes: e51df6ce668a ("mmc: host: sdhci-pci: Add Genesys Logic GL975x support")
Cc: stable@xxxxxxxxxxxxxxx
Kind regards
Uffe
