So are there any other concerns, comments or opinions about this? From: Christian Löhle <CLoehle@xxxxxxxxxxxxxx> Sent: Thursday, April 22, 2021 3:18 PM To: linux-kernel@xxxxxxxxxxxxxxx <linux-kernel@xxxxxxxxxxxxxxx>; linux-mmc@xxxxxxxxxxxxxxx <linux-mmc@xxxxxxxxxxxxxxx>; Christian Löhle <CLoehle@xxxxxxxxxxxxxx>; ulf.hansson@xxxxxxxxxx <ulf.hansson@xxxxxxxxxx> Cc: pali@xxxxxxxxxx <pali@xxxxxxxxxx>; huyue2@xxxxxxxxxx <huyue2@xxxxxxxxxx>; tiantao6@xxxxxxxxxxxxx <tiantao6@xxxxxxxxxxxxx> Subject: [PATCH] mmc: enable UHS voltage switch for SDSC if supported Ignore the reported capacity if the card otherwise reports UHS support. Currently SDSC cards reporting UHS support except for the CCS do not run through the voltage switch. While strictly speaking a SDSC card cannot support UHS in compliance with the standard, there is no good reason to throttle them that way. Especially for pSLCs in practice such cards benefit greatly by this patch, as they can be new and UHS supporting, but must not lie about their CCS. The behaviour of linux-mmc for SDSC is deviating from the standard anyway in such a case, as the card is treated as UHS card not supporting the voltage switch in general. Such a card will come up as mmc0: new ultra high speed SDR25 SD card at address 0001. Thus the subsystem will support CMD23 and others to the card. But if we deviate from the standard anyway, then we might as well not throttle SDSC to 25MB/s. Signed-off-by: Christian Loehle <cloehle@xxxxxxxxxxxxxx> --- drivers/mmc/core/sd.c | 7 +++---- 1 file changed, 3 insertions(+), 4 deletions(-) diff --git a/drivers/mmc/core/sd.c b/drivers/mmc/core/sd.c index 6fa51a6ed058..281ca2da8e0b 100644 --- a/drivers/mmc/core/sd.c +++ b/drivers/mmc/core/sd.c @@ -841,11 +841,10 @@ int mmc_sd_get_cid(struct mmc_host *host, u32 ocr, u32 *cid, u32 *rocr) return err; /* - * In case CCS and S18A in the response is set, start Signal Voltage - * Switch procedure. SPI mode doesn't support CMD11. + * In case S18A in the response is set, start Signal Voltage Switch + * procedure. SPI mode doesn't support CMD11. */ - if (!mmc_host_is_spi(host) && rocr && - ((*rocr & 0x41000000) == 0x41000000)) { + if (!mmc_host_is_spi(host) && rocr && (*rocr & 0x01000000)) { err = mmc_set_uhs_voltage(host, pocr); if (err == -EAGAIN) { retries--; -- 2.31.1 Hyperstone GmbH | Line-Eid-Strasse 3 | 78467 Konstanz Managing Directors: Dr. Jan Peter Berns. Commercial register of local courts: Freiburg HRB381782