Hi,
śr., 16 gru 2020 o 08:46 <kostap@xxxxxxxxxxx> napisał(a):
>
> From: Marcin Wojtas <mw@xxxxxxxxxxxx>
>
> This patch adds necessary flags in the device tree
> which enable HS400 mode on AP807 MMC controller
> on the CN913x-DB board.
>
> Signed-off-by: Marcin Wojtas <mw@xxxxxxxxxxxx>
> ---
> arch/arm64/boot/dts/marvell/cn9130-db.dts | 2 ++
> 1 file changed, 2 insertions(+)
>
> diff --git a/arch/arm64/boot/dts/marvell/cn9130-db.dts b/arch/arm64/boot/dts/marvell/cn9130-db.dts
> index ce49a70d88a0..79020e6d2792 100644
> --- a/arch/arm64/boot/dts/marvell/cn9130-db.dts
> +++ b/arch/arm64/boot/dts/marvell/cn9130-db.dts
> @@ -113,6 +113,8 @@
> &ap_sdhci0 {
> pinctrl-names = "default";
> bus-width = <8>;
> + mmc-ddr-1_8v;
> + mmc-hs400-1_8v;
> vqmmc-supply = <&ap0_reg_sd_vccq>;
> status = "okay";
> };
I can confirm all works fine on top of the mmc next branch:
[ 3.591989] mmc0: new HS400 MMC card at address 0001
Best regards,
Marcin
