For Intel controllers, SDHCI_RESET_ALL resets also CQHCI registers.
Normally, SDHCI_RESET_ALL is not used while CQHCI is enabled, but that can
happen on the error path. e.g. if mmc_cqe_recovery() fails, mmc_blk_reset()
is called which, for a eMMC that does not support HW Reset, will cycle the
bus power and the driver will perform SDHCI_RESET_ALL.
So whenever performing SDHCI_RESET_ALL ensure CQHCI is deactivated.
That will force the driver to reinitialize CQHCI when it is next used.
A similar change was done already for sdhci-msm, and other drivers using
CQHCI might benefit from a similar change, if they also have CQHCI reset
by SDHCI_RESET_ALL.
Fixes: 8ee82bda230fc9 ("mmc: sdhci-pci: Add CQHCI support for Intel GLK")
Cc: stable@xxxxxxxxxxxxxxx # 5.4.x: 0ffa6cfbd949: mmc: cqhci: Add cqhci_deactivate()
Cc: stable@xxxxxxxxxxxxxxx # 5.4+
Signed-off-by: Adrian Hunter <adrian.hunter@xxxxxxxxx>
---
drivers/mmc/host/sdhci-pci-core.c | 10 +++++++++-
1 file changed, 9 insertions(+), 1 deletion(-)
diff --git a/drivers/mmc/host/sdhci-pci-core.c b/drivers/mmc/host/sdhci-pci-core.c
index c0e081e48d3f..d0c8d39d5dbd 100644
--- a/drivers/mmc/host/sdhci-pci-core.c
+++ b/drivers/mmc/host/sdhci-pci-core.c
@@ -234,6 +234,14 @@ static void sdhci_pci_dumpregs(struct mmc_host *mmc)
sdhci_dumpregs(mmc_priv(mmc));
}
+static void sdhci_cqhci_reset(struct sdhci_host *host, u8 mask)
+{
+ if ((host->mmc->caps2 & MMC_CAP2_CQE) && (mask & SDHCI_RESET_ALL) &&
+ host->mmc->cqe_private)
+ cqhci_deactivate(host->mmc);
+ sdhci_reset(host, mask);
+}
+
/*****************************************************************************\
* *
* Hardware specific quirk handling *
@@ -722,7 +730,7 @@ static const struct sdhci_ops sdhci_intel_glk_ops = {
.set_power = sdhci_intel_set_power,
.enable_dma = sdhci_pci_enable_dma,
.set_bus_width = sdhci_set_bus_width,
- .reset = sdhci_reset,
+ .reset = sdhci_cqhci_reset,
.set_uhs_signaling = sdhci_set_uhs_signaling,
.hw_reset = sdhci_pci_hw_reset,
.irq = sdhci_cqhci_irq,
--
2.17.1
