20.05.2020 23:08, Sowjanya Komatineni пишет: > When auto calibration timeouts, calibration is disabled and fail-safe > drive strength values are programmed based on the signal voltage. > > Different fail-safe drive strength values based on voltage are > applicable only for SoCs supporting 3V3 and 1V8 pad controls. > > So, this patch avoids reading these properties from the device tree > for SoCs not using pad controls and the warning of missing properties > will not show up on these SoC platforms. > > Signed-off-by: Sowjanya Komatineni <skomatineni@xxxxxxxxxx> > --- > drivers/mmc/host/sdhci-tegra.c | 57 ++++++++++++++++++++++++------------------ > 1 file changed, 33 insertions(+), 24 deletions(-) Hello Sowjanya, Thank you for the patch. Tested-by: Dmitry Osipenko <digetx@xxxxxxxxx>
