If the tmio device is attached to a genpd (PM domain), that genpd may have ->start|stop() callback assigned to it. To make sure the device is accessible during ->probe(), genpd's ->start() callback must be invoked, which is currently managed by tmio_mmc_host_probe(). However, it's likely that may be too late for some cases, as registers may be read and written way before that point. To fix the behaviour, let's move the call to dev_pm_domain_start() from tmio_mmc_host_probe() into those clients that needs it. From discussions at linux-mmc mailing list, it turned out that it should be sufficient to do this for the SDHI renesas variants, hence the call is move to renesas_sdhi_probe(). Signed-off-by: Ulf Hansson <ulf.hansson@xxxxxxxxxx> --- drivers/mmc/host/renesas_sdhi_core.c | 3 +++ drivers/mmc/host/tmio_mmc_core.c | 2 -- 2 files changed, 3 insertions(+), 2 deletions(-) diff --git a/drivers/mmc/host/renesas_sdhi_core.c b/drivers/mmc/host/renesas_sdhi_core.c index ff72b381a6b3..dcba9ad35dd1 100644 --- a/drivers/mmc/host/renesas_sdhi_core.c +++ b/drivers/mmc/host/renesas_sdhi_core.c @@ -24,6 +24,7 @@ #include <linux/module.h> #include <linux/of_device.h> #include <linux/platform_device.h> +#include <linux/pm_domain.h> #include <linux/mmc/host.h> #include <linux/mmc/slot-gpio.h> #include <linux/mfd/tmio.h> @@ -905,6 +906,8 @@ int renesas_sdhi_probe(struct platform_device *pdev, /* All SDHI have SDIO status bits which must be 1 */ mmc_data->flags |= TMIO_MMC_SDIO_STATUS_SETBITS; + dev_pm_domain_start(&pdev->dev); + ret = renesas_sdhi_clk_enable(host); if (ret) goto efree; diff --git a/drivers/mmc/host/tmio_mmc_core.c b/drivers/mmc/host/tmio_mmc_core.c index ba301fb7656b..d7fde57c78c1 100644 --- a/drivers/mmc/host/tmio_mmc_core.c +++ b/drivers/mmc/host/tmio_mmc_core.c @@ -39,7 +39,6 @@ #include <linux/module.h> #include <linux/pagemap.h> #include <linux/platform_device.h> -#include <linux/pm_domain.h> #include <linux/pm_qos.h> #include <linux/pm_runtime.h> #include <linux/regulator/consumer.h> @@ -1192,7 +1191,6 @@ int tmio_mmc_host_probe(struct tmio_mmc_host *_host) /* See if we also get DMA */ tmio_mmc_request_dma(_host, pdata); - dev_pm_domain_start(&pdev->dev); pm_runtime_get_noresume(&pdev->dev); pm_runtime_set_active(&pdev->dev); pm_runtime_set_autosuspend_delay(&pdev->dev, 50); -- 2.20.1
