The STOP command is disabled for multiple blocks r/w commands
with auto CMD12, when start to send. However, if there is data
error, software still needs to send CMD12 according to SD spec.
This patch is to allow software CMD12 sending for this case.
Signed-off-by: Yangbo Lu <yangbo.lu@xxxxxxx>
---
drivers/mmc/host/sdhci.c | 17 +++--------------
1 file changed, 3 insertions(+), 14 deletions(-)
diff --git a/drivers/mmc/host/sdhci.c b/drivers/mmc/host/sdhci.c
index 09cdbe8..3041c39 100644
--- a/drivers/mmc/host/sdhci.c
+++ b/drivers/mmc/host/sdhci.c
@@ -1326,12 +1326,12 @@ static void sdhci_finish_data(struct sdhci_host *host)
/*
* Need to send CMD12 if -
- * a) open-ended multiblock transfer (no CMD23)
+ * a) open-ended multiblock transfer not using auto CMD12 (no CMD23)
* b) error in multiblock transfer
*/
if (data->stop &&
- (data->error ||
- !data->mrq->sbc)) {
+ ((!data->mrq->sbc && !sdhci_auto_cmd12(host, data->mrq)) ||
+ data->error)) {
/*
* 'cap_cmd_during_tfr' request must not use the command line
* after mmc_command_done() has been called. It is upper layer's
@@ -1825,17 +1825,6 @@ void sdhci_request(struct mmc_host *mmc, struct mmc_request *mrq)
sdhci_led_activate(host);
- /*
- * Ensure we don't send the STOP for non-SET_BLOCK_COUNTED
- * requests if Auto-CMD12 is enabled.
- */
- if (sdhci_auto_cmd12(host, mrq)) {
- if (mrq->stop) {
- mrq->data->stop = NULL;
- mrq->stop = NULL;
- }
- }
-
if (!present || host->flags & SDHCI_DEVICE_DEAD) {
mrq->cmd->error = -ENOMEDIUM;
sdhci_finish_mrq(host, mrq);
--
2.7.4
