On Thu, Oct 17, 2019 at 11:51:46AM +0530, Manish Narani wrote:
> Add optional propeties for Arasan SDHCI which are used to set clk delays
properties
> for different speed modes in the controller.
>
> Signed-off-by: Manish Narani <manish.narani@xxxxxxxxxx>
> ---
> .../devicetree/bindings/mmc/arasan,sdhci.txt | 15 +++++++++++++++
> 1 file changed, 15 insertions(+)
>
> diff --git a/Documentation/devicetree/bindings/mmc/arasan,sdhci.txt b/Documentation/devicetree/bindings/mmc/arasan,sdhci.txt
> index b51e40b2e0c5..e0369dd7fb18 100644
> --- a/Documentation/devicetree/bindings/mmc/arasan,sdhci.txt
> +++ b/Documentation/devicetree/bindings/mmc/arasan,sdhci.txt
> @@ -46,6 +46,21 @@ Optional Properties:
> properly. Test mode can be used to force the controller to function.
> - xlnx,int-clock-stable-broken: when present, the controller always reports
> that the internal clock is stable even when it is not.
> + - clk-phase-legacy: Input/Output Clock Delay pair in degrees for Legacy Mode.
> + - clk-phase-mmc-hs: Input/Output Clock Delay pair degrees for MMC HS.
> + - clk-phase-sd-hs: Input/Output Clock Delay pair in degrees for SD HS.
> + - clk-phase-uhs-sdr12: Input/Output Clock Delay pair in degrees for SDR12.
> + - clk-phase-uhs-sdr25: Input/Output Clock Delay pair in degrees for SDR25.
> + - clk-phase-uhs-sdr50: Input/Output Clock Delay pair in degrees for SDR50.
> + - clk-phase-uhs-sdr104: Input/Output Clock Delay pair in degrees for SDR104.
> + - clk-phase-uhs-ddr50: Input/Output Clock Delay pair in degrees for SD DDR50.
> + - clk-phase-mmc-ddr52: Input/Output Clock Delay pair in degrees for MMC DDR52.
> + - clk-phase-mmc-hs200: Input/Output Clock Delay pair in degrees for MMC HS200.
> + - clk-phase-mmc-hs400: Input/Output Clock Delay pair in degrees for MMC HS400.
Should be common?
Range of values?
> +
> + Above mentioned are the clock (phase) delays which are to be configured in the
> + controller while switching to particular speed mode. If not specified, driver
> + will configure the default value defined for particular mode in it.
>
> Example:
> sdhci@e0100000 {
> --
> 2.17.1
>
