Add binding documentation for mmc host controllers present on TI's J721E SOC. The 4 bit IP on J721E doesn't have a phy DLL so make DLL related properties as optional for that compatible. Also add an optional strobe-sel property used for HS400 speed mode. Signed-off-by: Faiz Abbas <faiz_abbas@xxxxxx> --- Documentation/devicetree/bindings/mmc/sdhci-am654.txt | 9 ++++++++- 1 file changed, 8 insertions(+), 1 deletion(-) diff --git a/Documentation/devicetree/bindings/mmc/sdhci-am654.txt b/Documentation/devicetree/bindings/mmc/sdhci-am654.txt index 15dbbbace27e..50e87df47971 100644 --- a/Documentation/devicetree/bindings/mmc/sdhci-am654.txt +++ b/Documentation/devicetree/bindings/mmc/sdhci-am654.txt @@ -8,7 +8,10 @@ Only deviations are documented here. [3] Documentation/devicetree/bindings/interrupt-controller/interrupts.txt Required Properties: - - compatible: should be "ti,am654-sdhci-5.1" + - compatible: should be one of: + "ti,am654-sdhci-5.1": SDHCI on AM654 device. + "ti,j721e-sdhci-8bit": 8 bit SDHCI on J721E device. + "ti,j721e-sdhci-4bit": 4 bit SDHCI on J721E device. - reg: Must be two entries. - The first should be the sdhci register space - The second should the subsystem/phy register space @@ -16,9 +19,13 @@ Required Properties: - clock-names: Tuple including "clk_xin" and "clk_ahb" - interrupts: Interrupt specifiers - ti,otap-del-sel: Output Tap Delay select + +Optional Properties (Required for ti,am654-sdhci-5.1 and ti,j721e-sdhci-8bit): - ti,trm-icp: DLL trim select - ti,driver-strength-ohm: driver strength in ohms. Valid values are 33, 40, 50, 66 and 100 ohms. +Optional Properties: + - ti,strobe-sel: strobe select delay for HS400 speed mode. Default value: 0x0. Example: -- 2.19.2
