This patch set is based on renesas-drivers.git / renesas-drivers-2019-05-07-v5.1 tag. Since SDHI host internal DMAC of the R-Car Gen3 cannot handle two or more segments, the performance rate (especially, eMMC HS400 reading) is not good. However, if IOMMU is enabled on the DMAC, since IOMMU will map multiple scatter gather buffers as one contignous iova, the DMAC can handle the iova as well and then the performance rate is possible to improve. In fact, I have measured the performance by using bonnie++, "Sequential Input - block" rate was improved on all platforms (r8a7795, r8a77965 and r8a77990). Please refer to the following URL about the performance. (I beleive if the performance is improved, the CPU load is also increased.) https://marc.info/?l=linux-renesas-soc&m=155625619320165&w=2 However, in case of a sdio card (especiialy some WiFi cards/drivers), scatter gather buffers are possible to be not contiguous iova because each scatter gather buffer has only about 1500 bytes, the DMAC cannot handle it. So, this patch set adds init_card() ops to detect the card type, and then the driver changes the max_segs if the DMAC is under IOMMU environment and an sd card/mmc is detected. Changes from v1 [1]: - Remove adding init_card ops into struct tmio_mmc_dma_ops and tmio_mmc_host and just set init_card on renesas_sdhi_core.c. - Revise typos on "mmc: tmio: No memory size limitation if runs on IOMMU". - Add Simon-san's Reviewed-by on a tmio patch. [1] https://patchwork.kernel.org/project/linux-renesas-soc/list/?series=110485 Yoshihiro Shimoda (2): mmc: tmio: No memory size limitation if runs on IOMMU mmc: renesas_sdhi: use multiple segments if possible drivers/mmc/host/renesas_sdhi_core.c | 13 +++++++++++++ drivers/mmc/host/tmio_mmc_core.c | 5 +++-- 2 files changed, 16 insertions(+), 2 deletions(-) -- 2.7.4
