According to the AM654x Data Manual[1], the setup timing in lower speed modes can only be met if the controller uses a falling edge data launch. To ensure this, the HIGH_SPEED_ENA (HOST_CONTROL[2]) bit should be cleared in default speed, SD high speed, MMC high speed, SDR12 and SDR25 speed modes. Enable the SDHCI_QUIRK2_TI_HISPD_BIT quirk to facilitate this. [1] http://www.ti.com/lit/gpn/am6546 Section 5.10.5.16.1 Signed-off-by: Faiz Abbas <faiz_abbas@xxxxxx> --- drivers/mmc/host/sdhci_am654.c | 3 ++- 1 file changed, 2 insertions(+), 1 deletion(-) diff --git a/drivers/mmc/host/sdhci_am654.c b/drivers/mmc/host/sdhci_am654.c index eea183e90f1b..739a91767d5a 100644 --- a/drivers/mmc/host/sdhci_am654.c +++ b/drivers/mmc/host/sdhci_am654.c @@ -172,7 +172,8 @@ static const struct sdhci_pltfm_data sdhci_am654_pdata = { .ops = &sdhci_am654_ops, .quirks = SDHCI_QUIRK_INVERTED_WRITE_PROTECT | SDHCI_QUIRK_MULTIBLOCK_READ_ACMD12, - .quirks2 = SDHCI_QUIRK2_PRESET_VALUE_BROKEN, + .quirks2 = SDHCI_QUIRK2_PRESET_VALUE_BROKEN | + SDHCI_QUIRK2_TI_HISPD_BIT, }; static int sdhci_am654_init(struct sdhci_host *host) -- 2.19.2
