[PATCH v5 2/5] mmc: sdhci-of-esdhc: add hs400 mode support

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



From: Yangbo Lu <yangbo.lu@xxxxxxx>

1.  Perform the Tuning Process at the HS400 target operating frequency.
    Latched the clock division value.
2.  if read transaction, then set the SDTIMNGCTL[FLW_CTL_BG].
3.  Switch to High Speed mode and then set the card clock frequency to
    a value not greater than 52Mhz
4.  Clear TBCTL[TB_EN],tuning block enable bit.
5.  Change to 8 bit DDR Mode
6.  Switch the card to HS400 mode.
7.  Set TBCTL[TB_EN], tuning block enable bit.
8.  Clear SYSCTL[SDCLKEN]
9.  Wait for PRSSTAT[SDSTB] to be set
10. Change the clock division to latched value.Set TBCTL[HS 400 mode]
    and Set SDCLKCTL[CMD_CLK_CTRL]
11. Set SYSCTL[SDCLKEN]
12. Wait for PRSSTAT[SDSTB] to be set
13. Set DLLCFG0[DLL_ENABLE] and DLLCFG0[DLL_FREQ_SEL].
14. Wait for delay chain to lock.
15. Set TBCTL[HS400_WNDW_ADJUST]
16. Again clear SYSCTL[SDCLKEN]
17. Wait for PRSSTAT[SDSTB] to be set
18. Set ESDHCCTL[FAF]
19. Wait for ESDHCCTL[FAF] to be cleared
20. Set SYSCTL[SDCLKEN]
21. Wait for PRSSTAT[SDSTB] to be set.

Signed-off-by: Yangbo Lu <yangbo.lu@xxxxxxx>
Signed-off-by: Yinbo Zhu <yinbo.zhu@xxxxxxx>
---
Change in v5:
		rebase this patch

 drivers/mmc/host/sdhci-esdhc.h    |   20 +++++++++
 drivers/mmc/host/sdhci-of-esdhc.c |   78 ++++++++++++++++++++++++++++++++-----
 2 files changed, 88 insertions(+), 10 deletions(-)

diff --git a/drivers/mmc/host/sdhci-esdhc.h b/drivers/mmc/host/sdhci-esdhc.h
index 3f16d9c..721a635 100644
--- a/drivers/mmc/host/sdhci-esdhc.h
+++ b/drivers/mmc/host/sdhci-esdhc.h
@@ -59,9 +59,29 @@
 
 /* Tuning Block Control Register */
 #define ESDHC_TBCTL			0x120
+#define ESDHC_HS400_WNDW_ADJUST		0x00000040
+#define ESDHC_HS400_MODE		0x00000010
 #define ESDHC_TB_EN			0x00000004
 #define ESDHC_TBPTR			0x128
 
+/* SD Clock Control Register */
+#define ESDHC_SDCLKCTL			0x144
+#define ESDHC_LPBK_CLK_SEL		0x80000000
+#define ESDHC_CMD_CLK_CTL		0x00008000
+
+/* SD Timing Control Register */
+#define ESDHC_SDTIMNGCTL		0x148
+#define ESDHC_FLW_CTL_BG		0x00008000
+
+/* DLL Config 0 Register */
+#define ESDHC_DLLCFG0			0x160
+#define ESDHC_DLL_ENABLE		0x80000000
+#define ESDHC_DLL_FREQ_SEL		0x08000000
+
+/* DLL Status 0 Register */
+#define ESDHC_DLLSTAT0			0x170
+#define ESDHC_DLL_STS_SLV_LOCK		0x08000000
+
 /* Control Register for DMA transfer */
 #define ESDHC_DMA_SYSCTL		0x40c
 #define ESDHC_PERIPHERAL_CLK_SEL	0x00080000
diff --git a/drivers/mmc/host/sdhci-of-esdhc.c b/drivers/mmc/host/sdhci-of-esdhc.c
index 86fc9f0..65419cb 100644
--- a/drivers/mmc/host/sdhci-of-esdhc.c
+++ b/drivers/mmc/host/sdhci-of-esdhc.c
@@ -592,6 +592,26 @@ static void esdhc_of_set_clock(struct sdhci_host *host, unsigned int clock)
 		| (pre_div << ESDHC_PREDIV_SHIFT));
 	sdhci_writel(host, temp, ESDHC_SYSTEM_CONTROL);
 
+	if (host->mmc->ios.timing == MMC_TIMING_MMC_HS400 &&
+	    clock == MMC_HS200_MAX_DTR) {
+		temp = sdhci_readl(host, ESDHC_TBCTL);
+		sdhci_writel(host, temp | ESDHC_HS400_MODE, ESDHC_TBCTL);
+		temp = sdhci_readl(host, ESDHC_SDCLKCTL);
+		sdhci_writel(host, temp | ESDHC_CMD_CLK_CTL, ESDHC_SDCLKCTL);
+		esdhc_clock_enable(host, true);
+
+		temp = sdhci_readl(host, ESDHC_DLLCFG0);
+		temp |= ESDHC_DLL_ENABLE | ESDHC_DLL_FREQ_SEL;
+		sdhci_writel(host, temp, ESDHC_DLLCFG0);
+		temp = sdhci_readl(host, ESDHC_TBCTL);
+		sdhci_writel(host, temp | ESDHC_HS400_WNDW_ADJUST, ESDHC_TBCTL);
+
+		esdhc_clock_enable(host, false);
+		temp = sdhci_readl(host, ESDHC_DMA_SYSCTL);
+		temp |= ESDHC_FLUSH_ASYNC_FIFO;
+		sdhci_writel(host, temp, ESDHC_DMA_SYSCTL);
+	}
+
 	/* Wait max 20 ms */
 	timeout = ktime_add_ms(ktime_get(), 20);
 	while (!(sdhci_readl(host, ESDHC_PRSSTAT) & ESDHC_CLOCK_STABLE)) {
@@ -603,6 +623,7 @@ static void esdhc_of_set_clock(struct sdhci_host *host, unsigned int clock)
 		udelay(10);
 	}
 
+	temp = sdhci_readl(host, ESDHC_SYSTEM_CONTROL);
 	temp |= ESDHC_CLOCK_SDCLKEN;
 	sdhci_writel(host, temp, ESDHC_SYSTEM_CONTROL);
 }
@@ -728,25 +749,46 @@ static int esdhc_signal_voltage_switch(struct mmc_host *mmc,
 	{ },
 };
 
-static int esdhc_execute_tuning(struct mmc_host *mmc, u32 opcode)
+static void esdhc_tuning_block_enable(struct sdhci_host *host, bool enable)
 {
-	struct sdhci_host *host = mmc_priv(mmc);
-	struct sdhci_pltfm_host *pltfm_host = sdhci_priv(host);
-	struct sdhci_esdhc *esdhc = sdhci_pltfm_priv(pltfm_host);
 	u32 val;
 
-	/* Use tuning block for tuning procedure */
 	esdhc_clock_enable(host, false);
+
 	val = sdhci_readl(host, ESDHC_DMA_SYSCTL);
 	val |= ESDHC_FLUSH_ASYNC_FIFO;
 	sdhci_writel(host, val, ESDHC_DMA_SYSCTL);
 
 	val = sdhci_readl(host, ESDHC_TBCTL);
-	val |= ESDHC_TB_EN;
+	if (enable)
+		val |= ESDHC_TB_EN;
+	else
+		val &= ~ESDHC_TB_EN;
 	sdhci_writel(host, val, ESDHC_TBCTL);
+
 	esdhc_clock_enable(host, true);
+}
+
+static int esdhc_execute_tuning(struct mmc_host *mmc, u32 opcode)
+{
+	struct sdhci_host *host = mmc_priv(mmc);
+	struct sdhci_pltfm_host *pltfm_host = sdhci_priv(host);
+	struct sdhci_esdhc *esdhc = sdhci_pltfm_priv(pltfm_host);
+	bool hs400_tuning;
+	u32 val;
+	int ret;
+
+	esdhc_tuning_block_enable(host, true);
+
+	hs400_tuning = host->flags & SDHCI_HS400_TUNING;
+	ret = sdhci_execute_tuning(mmc, opcode);
+
+	if (hs400_tuning) {
+		val = sdhci_readl(host, ESDHC_SDTIMNGCTL);
+		val |= ESDHC_FLW_CTL_BG;
+		sdhci_writel(host, val, ESDHC_SDTIMNGCTL);
+	}
 
-	sdhci_execute_tuning(mmc, opcode);
 	if (host->tuning_err == -EAGAIN && esdhc->quirk_fixup_tuning) {
 
 		/* program TBPTR[TB_WNDW_END_PTR] = 3*DIV_RATIO and
@@ -765,7 +807,16 @@ static int esdhc_execute_tuning(struct mmc_host *mmc, u32 opcode)
 		sdhci_writel(host, val, ESDHC_TBCTL);
 		sdhci_execute_tuning(mmc, opcode);
 	}
-	return 0;
+	return ret;
+}
+
+static void esdhc_set_uhs_signaling(struct sdhci_host *host,
+				   unsigned int timing)
+{
+	if (timing == MMC_TIMING_MMC_HS400)
+		esdhc_tuning_block_enable(host, true);
+	else
+		sdhci_set_uhs_signaling(host, timing);
 }
 
 #ifdef CONFIG_PM_SLEEP
@@ -814,7 +865,7 @@ static SIMPLE_DEV_PM_OPS(esdhc_of_dev_pm_ops,
 	.adma_workaround = esdhc_of_adma_workaround,
 	.set_bus_width = esdhc_pltfm_set_bus_width,
 	.reset = esdhc_reset,
-	.set_uhs_signaling = sdhci_set_uhs_signaling,
+	.set_uhs_signaling = esdhc_set_uhs_signaling,
 };
 
 static const struct sdhci_ops sdhci_esdhc_le_ops = {
@@ -831,7 +882,7 @@ static SIMPLE_DEV_PM_OPS(esdhc_of_dev_pm_ops,
 	.adma_workaround = esdhc_of_adma_workaround,
 	.set_bus_width = esdhc_pltfm_set_bus_width,
 	.reset = esdhc_reset,
-	.set_uhs_signaling = sdhci_set_uhs_signaling,
+	.set_uhs_signaling = esdhc_set_uhs_signaling,
 };
 
 static const struct sdhci_pltfm_data sdhci_esdhc_be_pdata = {
@@ -909,6 +960,12 @@ static void esdhc_init(struct platform_device *pdev, struct sdhci_host *host)
 	}
 }
 
+static int esdhc_prepare_ddr_to_hs400(struct mmc_host *mmc)
+{
+	esdhc_tuning_block_enable(mmc_priv(mmc), false);
+	return 0;
+}
+
 static int sdhci_esdhc_probe(struct platform_device *pdev)
 {
 	struct sdhci_host *host;
@@ -932,6 +989,7 @@ static int sdhci_esdhc_probe(struct platform_device *pdev)
 	host->mmc_host_ops.start_signal_voltage_switch =
 		esdhc_signal_voltage_switch;
 	host->mmc_host_ops.execute_tuning = esdhc_execute_tuning;
+	host->mmc_host_ops.prepare_ddr_to_hs400 = esdhc_prepare_ddr_to_hs400;
 	host->tuning_delay = 1;
 
 	esdhc_init(pdev, host);
-- 
1.7.1




[Index of Archives]     [Linux Memonry Technology]     [Linux USB Devel]     [Linux Media]     [Video for Linux]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]

  Powered by Linux