On 12 July 2018 at 10:06, Stefan Agner <stefan@xxxxxxxx> wrote:
> In the uSDHC case (e.g. i.MX 6) clocks only get disabled if frequency
> is set to 0. However, it could be that the stack asks for a frequency
> change while clocks are on. In that case the function clears the
> divider registers (by clearing ESDHC_CLOCK_MASK) while the clock is
> enabled! This causes a short period of time where the clock is
> undivided (on a i.MX 6DL a clock of 196MHz has been measured).
>
> For older IP variants the driver disables clock by clearing some bits
> in ESDHC_SYSTEM_CONTROL.
>
> Make sure to disable card clock before changing frequency for uSDHC
> IP variants too.
>
> Signed-off-by: Stefan Agner <stefan@xxxxxxxx>
Thanks, applied for next!
Kind regards
Uffe
> ---
> drivers/mmc/host/sdhci-esdhc-imx.c | 12 ++++++------
> 1 file changed, 6 insertions(+), 6 deletions(-)
>
> diff --git a/drivers/mmc/host/sdhci-esdhc-imx.c b/drivers/mmc/host/sdhci-esdhc-imx.c
> index 85fd5a8b0b6d..acacd8481473 100644
> --- a/drivers/mmc/host/sdhci-esdhc-imx.c
> +++ b/drivers/mmc/host/sdhci-esdhc-imx.c
> @@ -708,14 +708,14 @@ static inline void esdhc_pltfm_set_clock(struct sdhci_host *host,
> int div = 1;
> u32 temp, val;
>
> + if (esdhc_is_usdhc(imx_data)) {
> + val = readl(host->ioaddr + ESDHC_VENDOR_SPEC);
> + writel(val & ~ESDHC_VENDOR_SPEC_FRC_SDCLK_ON,
> + host->ioaddr + ESDHC_VENDOR_SPEC);
> + }
> +
> if (clock == 0) {
> host->mmc->actual_clock = 0;
> -
> - if (esdhc_is_usdhc(imx_data)) {
> - val = readl(host->ioaddr + ESDHC_VENDOR_SPEC);
> - writel(val & ~ESDHC_VENDOR_SPEC_FRC_SDCLK_ON,
> - host->ioaddr + ESDHC_VENDOR_SPEC);
> - }
> return;
> }
>
> --
> 2.18.0
>
> --
> To unsubscribe from this list: send the line "unsubscribe linux-mmc" in
> the body of a message to majordomo@xxxxxxxxxxxxxxx
> More majordomo info at http://vger.kernel.org/majordomo-info.html
--
To unsubscribe from this list: send the line "unsubscribe linux-mmc" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
