Linus, Adrian, On 28 November 2017 at 10:42, Linus Walleij <linus.walleij@xxxxxxxxxx> wrote: > On Tue, Nov 21, 2017 at 2:42 PM, Adrian Hunter <adrian.hunter@xxxxxxxxx> wrote: > >> Here is V14 of the hardware command queue patches without the software >> command queue patches, now using blk-mq and now with blk-mq support for >> non-CQE I/O. >> >> V14 includes a number of fixes to existing code, changes to default to >> blk-mq, and adds patches to remove legacy code. > > I have looked over the code, I was unable to find a good mergebase to apply > it on (I guess it is based on linux-next at some date in the past) so mostly > I just looked at it overall, and I can solidly say that this patch series: > > Acked-by: Linus Walleij <linus.walleij@xxxxxxxxxx> Great, thanks! > > I gave some more explicit review on some initial patches that I think > should go in as fixes. Thanks, and already taken care of. > > I do not expect it to perform any less than the previous iteration on my > systems where it was already performing well and Bartlomiej also has > confirmed that the patch set works for him. > > Ulf: I suggest this be applied (+/- some rebasing) early for v4.15. Yes, I am up for that! I have now also completed my review of the series and in the end, most of my comments turned out to be of minor issues, hopefully easily addressed. > > I am positively convinced that we can make things work on top of this. > >> HW CMDQ offers 25% - 50% better random multi-threaded I/O. I see a slight >> 2% drop in sequential read speed but no change to sequential write. > > Fully acceptable I think. > >> Non-CQE blk-mq showed a 3% decrease in sequential read performance. This >> seemed to be coming from the inferior latency of running work items compared >> with a dedicated thread. Hacking blk-mq workqueue to be unbound reduced the >> performance degradation from 3% to 1%. > > Also acceptable I think. > >> While we should look at changing blk-mq to give better workqueue performance, >> a bigger gain is likely to be made by adding a new host API to enable the >> next already-prepared request to be issued directly from within ->done() >> callback of the current request. I assume that is taken care of by adding the new host cap (MMC_CAP_DIRECT_COMPLETE). So, then it's just a matter of adopting all host drivers, and when we are done with that, we can remove that cap. :-) > > I agree. > > Yours, > Linus Walleij I am awaiting a re-based v15 version - and eager to apply it! :-) Thanks and kind regards Uffe -- To unsubscribe from this list: send the line "unsubscribe linux-mmc" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
