On 6 September 2017 at 13:45, Kishon Vijay Abraham I <kishon@xxxxxx> wrote: > This is the first step in deprecating omap_hsmmc driver completely > and moving to sdhci-omap driver which uses the sdhci library. > > This patch that adds a new SDHCI quirk "MMC_RSP_136" has already been > merged and hence removed it in this revision. > > Apart from the quirk, sdhci-omap has it's own callbacks > to set_clock (clock divider programming is different from generic sdhci) > , set_power, set_bus_width, set_bus_mode and platform_send_init_74_clocks. > These callback functions are implemented based on omap_hsmmc driver. > Since sdhci-omap driver requires pbias regulator fixes to be present, I've > sent them as part of this series. > > The sdhci-omap driver supports only the high speed mode and UHS/HS200 > mode will be added in a later series. > > It has been tested only in boards having DRA7 SoCs like dra7-evm, dra72-evm, > am571x-idk, am572x-idk, am57xx-evm. (Tested only eMMC and SD. > SDIO support will be added later). The plan is to fully convert DRA7 > SoC to use SDHCI driver and then convert other legacy platforms to use > SDHCI. > > For sdhci-omap to be functional, the following tag should be merged (There > are no compilation dependencies). > git://git.kernel.org/pub/scm/linux/kernel/git/broonie/regulator > tags/regulator-pbias-variants Tag pulled. > > However the above regulator tag will impact omap_hsmmc driver. so [1] > should be merged before everything else is merged. > > [1] -> https://lkml.org/lkml/2017/8/31/300 Applied. > > The patch to add config and dts changes to use sdhci-omap will be sent > separately. > > Next Steps: > *) Add UHS support to sdhci-omap > *) Add SDIO support > *) Add support for older TI platforms > > Changes from v3: > *) removed omap_hsmmc and pbias-regulator patches from the series > *) Fixed dt-binding documentation (remove '0x' in node name) > *) stop clock if MMC core sends '0' in frequency > > Changes from v2: > *) Rebased on git://git.kernel.org/pub/scm/linux/kernel/git/ulfh/mmc.git next > *) Included a couple of patches from Ravikumar to fix pbias-regulator driver > to support max-voltage of 3.3V. This is required for sdhci-omap driver. > *) Create sdhci-omap as a new driver with MMC generic bindings and hence doesn't > have bindings like ti,dual-volt added for omap-hsmmc. (Instead of > ti,dual-volt, sdhci-omap driver uses the supported regulator voltage to > set controller IO voltage capabilities). > When omap-hsmmc driver is deprecated, support for these properties will > be added to sdhci-omap. > *) Fixed minor comments from Adrian). > > Changes from v1: > *) Remove the quirks and instead use sdhci_omap specific callbacks for > set_power, set_busmode etc. > *) Add a patch from Adrian to tidy reading 136-bit responses > > I've also pushed the entire series along with dependent dt patches @ > https://github.com/kishon/linux-wip.git sdhci_v3 (in case someone > wants to test) > > Kishon Vijay Abraham I (3): > dt-bindings: sdhci-omap: Add bindings for the sdhci-omap controller > mmc: sdhci-omap: Add OMAP SDHCI driver > MAINTAINERS: Add TI OMAP SDHCI Maintainer > > .../devicetree/bindings/mmc/sdhci-omap.txt | 16 + > MAINTAINERS | 6 + > drivers/mmc/host/Kconfig | 12 + > drivers/mmc/host/Makefile | 1 + > drivers/mmc/host/sdhci-omap.c | 607 +++++++++++++++++++++ > 5 files changed, 642 insertions(+) > create mode 100644 Documentation/devicetree/bindings/mmc/sdhci-omap.txt > create mode 100644 drivers/mmc/host/sdhci-omap.c > > -- > 2.11.0 > Thanks, everything applied/pulled for next! Great work! Kind regards Uffe -- To unsubscribe from this list: send the line "unsubscribe linux-mmc" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
