On 30/08/17 16:04, Ritesh Harjani wrote:
> When CMDQ is halted the HW expects descriptor size to
> be same which is using in CMDQ mode.
> Thus adjust the desc_sz of sdhci accordingly.
>
> Without this patch below command gives ADMA error
> when CQE is enabled.
> cat /sys/kernel/debug/mmc0/mmc0:0001/ext_csd
>
> Signed-off-by: Ritesh Harjani <riteshh@xxxxxxxxxxxxxx>
> ---
> drivers/mmc/host/sdhci-msm.c | 24 ++++++++++++++++++++++--
> 1 file changed, 22 insertions(+), 2 deletions(-)
>
> diff --git a/drivers/mmc/host/sdhci-msm.c b/drivers/mmc/host/sdhci-msm.c
> index 346cdfb..baa3409 100644
> --- a/drivers/mmc/host/sdhci-msm.c
> +++ b/drivers/mmc/host/sdhci-msm.c
> @@ -1111,9 +1111,29 @@ static u32 sdhci_msm_cqe_irq(struct sdhci_host *host, u32 intmask)
> return 0;
> }
>
> +void sdhci_msm_cqe_enable(struct mmc_host *mmc)
> +{
> + struct sdhci_host *host = mmc_priv(mmc);
> +
> + if (host->flags & SDHCI_USE_64_BIT_DMA)
> + host->desc_sz = 12;
This has no effect.
> +
> + sdhci_cqe_enable(mmc);
> +}
> +
> +void sdhci_msm_cqe_disable(struct mmc_host *mmc, bool recovery)
> +{
> + struct sdhci_host *host = mmc_priv(mmc);
> +
> + if (host->flags & SDHCI_USE_64_BIT_DMA)
> + host->desc_sz = 16;
You can't change the descriptor size this way. If you need 128-bit ADMA
descriptors it must be done in sdhci_setup_host().
> +
> + sdhci_cqe_disable(mmc, recovery);
> +}
> +
> static const struct cqhci_host_ops sdhci_msm_cqhci_ops = {
> - .enable = sdhci_cqe_enable,
> - .disable = sdhci_cqe_disable,
> + .enable = sdhci_msm_cqe_enable,
> + .disable = sdhci_msm_cqe_disable,
> };
>
> #ifdef CONFIG_MMC_CQHCI
>
--
To unsubscribe from this list: send the line "unsubscribe linux-mmc" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
