Hi ,
On 08/15/2017 05:32 PM, Shawn Lin wrote:
Hi
On 2017/8/16 6:40, Zhoujie Wu wrote:
Hi Shawn,
----------------------------------------------------------------------
Hi
On 2017/8/15 6:19, Zhoujie Wu wrote:
On some platforms, like armada3700, SD card need to
do hard reset by gpio toggling to make it work properly
after warm reset the board.
I don't get this that SD card need to do hard reset...
I assume what you talk about is either for eMMC or a power-cycle
for SD card.
The subject of the patch confused you. What I want is a power-cycle
for the SD card. The gpio is used to enable/disable the vdd power
supply for sd card.
Actually on a3700, when warm reset the board, their is no power-cycle
for SD card, which will lead sd card can't response correct ocr and
never set S18A unless a power-cycle.
This is the purpose I submit this patch.
Well, if that is the case, I suggest you to use regulator-gpio.
i.e:
vcc_sd: regulator {
compatible = "regulator-gpio";
regulator-name = "vcc_sd";
regulator-min-microvolt = <3300000>;
regulator-max-microvolt = <3300000>;
gpios = <&gpio1 23 GPIO_ACTIVE_HIGH>;
enable-active-high;
};
&sdhci {
vmmc-supply = <&vcc_sd>;
}
I tried to use the vmmc-supply regulator before I submit this patch, I
met a issue in this case.
sdhci_set_power_reg will be called instead, and I saw
mmc_regulator_set_ocr do enabled the regulator, after that SW will set
0xf to power controller register, but the register is self-cleared to 0
soon which lead to later cmd timeout all the time.
Have you ever met similar issue before?
Add gpio hard reset feature for this purpose.
--
To unsubscribe from this list: send the line "unsubscribe linux-mmc" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
