Re: [PATCH] mmc: renesas_sdhi: use extra flag for CBSY usage

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Wed, Aug 09, 2017 at 09:00:41PM +0200, Wolfram Sang wrote:
> There is one SDHI instance on Gen2 which does not have the CBSY bit.
> So, turn CBSY usage into an extra flag and set it accordingly. This has
> the additional advantage that we can also set it for other incarnations
> later.

What is the run-time effect, if any, of this change?

> Signed-off-by: Wolfram Sang <wsa+renesas@xxxxxxxxxxxxxxxxxxxx>

Code looks good:

Reviewed-by: Simon Horman <horms+renesas@xxxxxxxxxxxx>

> ---
> 
> Tested on a M3-W Salvator-X and H2 Lager (with both SDHI instances). I could
> move large files around without problems. Note that on the special incarnation
> without the CBSY bit, the old code still worked, so there might be a CBSY bit.
> But it is not documented, so we better play safe.
> 
> Chris: according to the specs I have, we can enable it for RZ as well. I'll
> send a patch for that in a minute. If you could test this on top of this one,
> that would be much appreciated! Thanks.

I take it from the above you did a pass of the available documentation to
see which SoCs support this feature. If so, thanks!

>  drivers/mmc/host/renesas_sdhi_core.c          | 6 +++++-
>  drivers/mmc/host/renesas_sdhi_internal_dmac.c | 3 ++-
>  drivers/mmc/host/renesas_sdhi_sys_dmac.c      | 6 ++++--
>  include/linux/mfd/tmio.h                      | 3 +++
>  4 files changed, 14 insertions(+), 4 deletions(-)
> 
> diff --git a/drivers/mmc/host/renesas_sdhi_core.c b/drivers/mmc/host/renesas_sdhi_core.c
> index a252145097d6a5..e46504edc9fcb4 100644
> --- a/drivers/mmc/host/renesas_sdhi_core.c
> +++ b/drivers/mmc/host/renesas_sdhi_core.c
> @@ -429,7 +429,7 @@ static int renesas_sdhi_write16_hook(struct tmio_mmc_host *host, int addr)
>  	case CTL_TRANSACTION_CTL:
>  	case CTL_DMA_ENABLE:
>  	case EXT_ACC:
> -		if (host->pdata->flags & TMIO_MMC_MIN_RCAR2)
> +		if (host->pdata->flags & TMIO_MMC_HAVE_CBSY)
>  			bit = TMIO_STAT_CMD_BUSY;
>  		/* fallthrough */
>  	case CTL_SD_CARD_CLK_CTL:
> @@ -589,6 +589,10 @@ int renesas_sdhi_probe(struct platform_device *pdev,
>  	if (ret < 0)
>  		goto efree;
>  
> +	/* One Gen2 SDHI incarnation does NOT have a CBSY bit */
> +	if (sd_ctrl_read16(host, CTL_VERSION) == SDHI_VER_GEN2_SDR50)
> +		mmc_data->flags &= ~TMIO_MMC_HAVE_CBSY;
> +
>  	/* Enable tuning iff we have an SCC and a supported mode */
>  	if (of_data && of_data->scc_offset &&
>  	    (host->mmc->caps & MMC_CAP_UHS_SDR104 ||
> diff --git a/drivers/mmc/host/renesas_sdhi_internal_dmac.c b/drivers/mmc/host/renesas_sdhi_internal_dmac.c
> index 6717003888e292..fa4e71d3b47d47 100644
> --- a/drivers/mmc/host/renesas_sdhi_internal_dmac.c
> +++ b/drivers/mmc/host/renesas_sdhi_internal_dmac.c
> @@ -72,7 +72,8 @@ static struct renesas_sdhi_scc rcar_gen3_scc_taps[] = {
>  
>  static const struct renesas_sdhi_of_data of_rcar_gen3_compatible = {
>  	.tmio_flags	= TMIO_MMC_HAS_IDLE_WAIT | TMIO_MMC_WRPROTECT_DISABLE |
> -			  TMIO_MMC_CLK_ACTUAL | TMIO_MMC_MIN_RCAR2,
> +			  TMIO_MMC_CLK_ACTUAL | TMIO_MMC_HAVE_CBSY |
> +			  TMIO_MMC_MIN_RCAR2,
>  	.capabilities	= MMC_CAP_SD_HIGHSPEED | MMC_CAP_SDIO_IRQ |
>  			  MMC_CAP_CMD23,
>  	.bus_shift	= 2,

Keeping the above of_rcar_gen3_compatible structure in sync with the one
below may get painful at some point. Perhaps we should consider a common
location for it? (Yes, I know this is my handiwork)

> diff --git a/drivers/mmc/host/renesas_sdhi_sys_dmac.c b/drivers/mmc/host/renesas_sdhi_sys_dmac.c
> index 718cb8a9d2ce8d..9b77f521cd2c2f 100644
> --- a/drivers/mmc/host/renesas_sdhi_sys_dmac.c
> +++ b/drivers/mmc/host/renesas_sdhi_sys_dmac.c
> @@ -58,7 +58,8 @@ static struct renesas_sdhi_scc rcar_gen2_scc_taps[] = {
>  
>  static const struct renesas_sdhi_of_data of_rcar_gen2_compatible = {
>  	.tmio_flags	= TMIO_MMC_HAS_IDLE_WAIT | TMIO_MMC_WRPROTECT_DISABLE |
> -			  TMIO_MMC_CLK_ACTUAL | TMIO_MMC_MIN_RCAR2,
> +			  TMIO_MMC_CLK_ACTUAL | TMIO_MMC_HAVE_CBSY |
> +			  TMIO_MMC_MIN_RCAR2,
>  	.capabilities	= MMC_CAP_SD_HIGHSPEED | MMC_CAP_SDIO_IRQ |
>  			  MMC_CAP_CMD23,
>  	.dma_buswidth	= DMA_SLAVE_BUSWIDTH_4_BYTES,
> @@ -78,7 +79,8 @@ static struct renesas_sdhi_scc rcar_gen3_scc_taps[] = {
>  
>  static const struct renesas_sdhi_of_data of_rcar_gen3_compatible = {
>  	.tmio_flags	= TMIO_MMC_HAS_IDLE_WAIT | TMIO_MMC_WRPROTECT_DISABLE |
> -			  TMIO_MMC_CLK_ACTUAL | TMIO_MMC_MIN_RCAR2,
> +			  TMIO_MMC_CLK_ACTUAL | TMIO_MMC_HAVE_CBSY |
> +			  TMIO_MMC_MIN_RCAR2,
>  	.capabilities	= MMC_CAP_SD_HIGHSPEED | MMC_CAP_SDIO_IRQ |
>  			  MMC_CAP_CMD23,
>  	.bus_shift	= 2,
> diff --git a/include/linux/mfd/tmio.h b/include/linux/mfd/tmio.h
> index 18b17a39d465ed..b572955e6de6ab 100644
> --- a/include/linux/mfd/tmio.h
> +++ b/include/linux/mfd/tmio.h
> @@ -107,6 +107,9 @@
>   */
>  #define TMIO_MMC_CLK_ACTUAL		BIT(10)
>  
> +/* Some controllers have a CBSY bit */
> +#define TMIO_MMC_HAVE_CBSY		BIT(11)
> +
>  int tmio_core_mmc_enable(void __iomem *cnf, int shift, unsigned long base);
>  int tmio_core_mmc_resume(void __iomem *cnf, int shift, unsigned long base);
>  void tmio_core_mmc_pwr(void __iomem *cnf, int shift, int state);
> -- 
> 2.11.0
> 
--
To unsubscribe from this list: send the line "unsubscribe linux-mmc" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html



[Index of Archives]     [Linux USB Devel]     [Linux Media]     [Video for Linux]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]

  Powered by Linux