There are lots of debug message in core.c which use pr_debug
for better dynamic log level control. So it doesn't make sense
for those print to still keep working only under CONFIG_MMC_DEBUG.
Signed-off-by: Shawn Lin <shawn.lin@xxxxxxxxxxxxxx>
---
Changes in v2: None
drivers/mmc/core/core.c | 13 ++++---------
1 file changed, 4 insertions(+), 9 deletions(-)
diff --git a/drivers/mmc/core/core.c b/drivers/mmc/core/core.c
index 634f9ca..731aa9f 100644
--- a/drivers/mmc/core/core.c
+++ b/drivers/mmc/core/core.c
@@ -2436,10 +2436,9 @@ static int mmc_rescan_try_freq(struct mmc_host *host, unsigned freq)
{
host->f_init = freq;
-#ifdef CONFIG_MMC_DEBUG
- pr_info("%s: %s: trying to init card at %u Hz\n",
+ pr_debug("%s: %s: trying to init card at %u Hz\n",
mmc_hostname(host), __func__, host->f_init);
-#endif
+
mmc_power_up(host, host->ocr_avail);
/*
@@ -2670,9 +2669,7 @@ int mmc_power_save_host(struct mmc_host *host)
{
int ret = 0;
-#ifdef CONFIG_MMC_DEBUG
- pr_info("%s: %s: powering down\n", mmc_hostname(host), __func__);
-#endif
+ pr_debug("%s: %s: powering down\n", mmc_hostname(host), __func__);
mmc_bus_get(host);
@@ -2696,9 +2693,7 @@ int mmc_power_restore_host(struct mmc_host *host)
{
int ret;
-#ifdef CONFIG_MMC_DEBUG
- pr_info("%s: %s: powering up\n", mmc_hostname(host), __func__);
-#endif
+ pr_debug("%s: %s: powering up\n", mmc_hostname(host), __func__);
mmc_bus_get(host);
--
1.9.1
--
To unsubscribe from this list: send the line "unsubscribe linux-mmc" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
